User manual D-LINK DI-524UP QUICK INSTALL GUIDE

[. . . ] The DI-524UP acts as a DHCP server and will assign all the necessary IP address information on your network. See Appendix at the end of this Quick Installation Guide or the Manual on the CD-ROM for setting each network adapter to automatically obtain an IP address. Check Your Package Contents DI-524UP AirPlus G 802. g/2. 4GHz Wireless Router CD-ROM (containing Manual and Warranty) Ethernet (CAT5 UTP/Straight Through) Cable Using a power supply with a different voltage rating will damage and void the warranty of this product. 5V 2A DC Power Adapter If any of the above items are missing, please contact your reseller. ©2004, 2005 D-Link Systems, Inc. Trademarks or registered trademarks are the property of their respective holders. [. . . ] The LED light for LAN Port 1 illuminates to indicate proper connection. Meaning you can use a straight-through or crossover-Ethernet cable in the LAN Ports. ) D. Computers equipped with 802. 11g wireless adapters will be able to connect to the DI-524UP. The DWL-G630 AirPlus G Wireless Cardbus Adapter and the DWL-G510 AirPlus G Wireless PCI Adapter will be able to connect out of the box with the router using their default wireless settings. Connect one end of the printer cable to your printer and the other end to the DI-524UP. WAN PORT This is for the connection of an Ethernet cable to the Cable or DSL modem. Antenna Used to wirelessly connect to 802. 11g or 802. 11b adapters. C. LAN PORTS These are the connections for Ethernet cables to Ethernet enabled computers. E. USB Port You can connect a Printer to the USB Port here. Reset Button Pressing this button restores the Router to its original factory default settings. 2 Restart Your Computer Connecting Additional Computers To The DI-524UP Using additional Ethernet (CAT5 UTP) cables, connect your Ethernet-equipped computers to the remaining Ethernet LAN ports on the back panel of the DI-524UP. Power LED ­ a solid light indicates a proper connection to the power supply. Status LED ­ a blinking light indicates that the DI-524UP is functioning properly. LOCAL NETWORK LEDs ­ a solid light on the port indicates a connection to an Ethernet enabled computer on ports 1-4. This LED blinks during data transmission. WAN LED ­ a solid light indicates connection on the WAN port. This LED blinks during data transmission. WLAN LED ­ a solid light indicates that the wireless segment is ready. This LED blinks during wireless data transmission. When you have completed the steps in this Quick Installation Guide, your connected network should look similar to this: Using The Setup Wizard Open your Web browser and type "http://92. 68. 0. " into the URL address box. Then press the Enter or Return key. The logon pop-up screen will appear. Type "admin" for the username and leave the password field blank. Click OK Once you have logged in, the Home screen will appear. Click Run Wizard 4 The Setup Wizard (continued) You will see the following screens: Click Next Set up your new password. [. . . ] Click to Exit Then relaunch your Web browser (i. e. , Internet Explorer or Netscape Navigator), to link to your favorite Web site to test your Internet connection. For additional settings or information, refer to the Advanced, Tools, or Status tabs on the web-management interface; or to the Manual located on the CD. 9 APPENDIX To connect to the network, make sure the network adapter in your computer is configured properly. Here's how to configure the network adapter to obtain an IP address automatically for the DI-524UP Wireless Broadband Router. [. . . ]