User manual D-LINK DGE-528T

[. . . ] 27 2 Introduction The D-Link DGE-528T is ideal for the small office or home office environment. After completing the steps in this manual, you will have the ability to share information and resources - such as files and printers - and take full advantage of a “connected” environment for work and play!The DGE-528T comes with drivers for the most popular operating systems and can be integrated into a larger network. However, this manual is designed to help you network two computers running Windows 95/98, Windows Me and Windows 2000 in a peer-to-peer configuration. [. . . ] 13 Networking Basics Naming your Computer To name your computer, please follow these directions: In Windows XP: Click Start (in the lower left corner of the screen) Right-click on My Computer Select Properties and click Select the Computer Name Tab in the System Properties window. You may enter a Computer Description if you wish, this field is optional. 14 Networking Basics Naming your Computer In this window, enter the computer name. Click OK Checking the IP Address in Windows XP/2000 Go to Start >Run 15 Networking Basics Type in Command Click OK Type ipconfig /all at the prompt. Checking the IP Address in Windows XP/2000 Type ipconfig /renew at the prompt to get a new IP Address. ) 16 Assigning a Static IP Address Note: Residential Gateways/Broadband Routers will automatically assign IP Addresses to the computers on the network, using DHCP (Dynamic Host Configuration Protocol) technology. If you are using a DHCP-capable Gateway/Router you will not need to assign Static IP Addresses. If you are not using a DHCP capable Gateway/Router, or you need to assign a Static IP Address, please follow these instructions: Go to Start Click on Control Panel Click on Network Connections 17 Assigning a Static IP Address continued Highlight Internet Protocol (TCP/IP) Click Properties Select Use the following IP Address in the Internet Protocol (TCP/IP) Properties window Input your IP Address and subnet mask. 2, the other computers should have IP Addresses that are sequential, like 192. The subnet mask must be the same for all the computers on the network. Double-click the “D-LinkDGE-528T Gigabit Ethernet PCI Adapter” to read the explanation of the problem. This information will be helpful if you require technical support from D-Link. Verify Cable Connections Check to see that the computer(s) you are troubleshooting are properly connected. Each computer must be connected from its DGE-528T with Category 5 UTP cables. Examine the Network cables and ensure that they have not been damaged by walking-on, rolling over with chairs, or closed in doors. Additionally, make note of and alleviate any possible electromagnetic interference that may be affecting your network. Your network cables can be plugged into any port on your hub except the “Uplink” port. The “Uplink” port is only used when connecting your hub to another hub or switch. Understanding Indicators Your DGE-528T has indicators or lights that can give you information about your network traffic and help you determine problems when troubleshooting. Your DGE-528T have two indicators labeled “ACT” and “LINK” on their back panels. A steady green “LINK” light indicates a good connection with the switch. A flashing green “ACT” light indicates that the Network Adapter is sending or receiving data. [. . . ] Some states do not allow exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the foregoing limitations and exclusions may not apply. This limited warranty provides specific legal rights and the product owner may also have other rights which vary from state to state. 31 FCC Certifications This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide This reasonable protection against harmful interference in a residential installation. [. . . ]