User manual CYBERPOWER CPS325SL

[. . . ] User Manual for: CPS325SL and PowerPanelTM Software ADDITIONAL INSTALLATION TIPS CAN BE FOUND AT: http://www. cyberpowersystems. com/FAQs. htm TABLE OF CONTENTS Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Determining Power Requirements. . . . . 1 Hardware Installation Guide. . . . . . . . . . . . . 2 Software Installation Guide. . . . . . . . . . . . . . 3 Software User Manual. . . . . . . . . . . . . . . . . . . . 4 LED Indicators. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Troubleshooting Guide. . . . . . . . . . . . . . . . . . . . . . . . 8 Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Battery Replacement Instructions. . . . . . . . . . . 9 Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Thank you for purchasing a CyberPower Systems Product. To enjoy all the features and benefits of this Uninterruptible Power System (UPS), please read and follow all installation and operation instructions completely. This UPS is designed to provide guaranteed power protection for connected electronic equipment. [. . . ] Please contact your network administrator for further assistance. TESTING YOUR UPS SYSTEM Once you have set up your UPS system, you may wish to test it. Make sure that the UPS has been charged for at least 4 hours before performing this test. 2. 3. With your UPS and computer on, open an application such as notepad. Unplug the UPS from the AC outlet. When a power failure occurs, PowerPanelTM will appear on the screen. The outlet and battery symbols will change to indicate a power failure. When the timer reaches zero, the software will begin to save and close any open applications. The software will auto-assign names to any files that have not been previously saved, and then save the file to the PCTemp folder which is located in the root directory of your C drive (where C is the name of your main hard drive). Once all open files have been saved and closed, PowerPanelTM will shutdown the operating system. Once the operating system is shutdown, the UPS will turn off within 90 seconds. Wait until the UPS has turned off before plugging the UPS back into the outlet. Once the test has been completed, plug the UPS back into the wall and turn it back on. Please allow 4 hours for the UPS to recharge before attempting another self-test. Once the computer system is shutdown, turn the UPS off. As the battery discharges, the unit will beep more rapidly, indicating that the battery is nearing discharge. Once the test is complete, plug the UPS back in and start your computer. Please allow 4 hours for the UPS to recharge before attempting another self-test. 6 CPS325SL Guaranteed Uninterruptible Power System DEFINITIONS FOR ILLUMINATED LED INDICATORS CONDITION On Off Off Two Beeps Off Rapid Beeps Two Beeps or Rapid Beeps Off Off Long Beep On/Off None Utility Failure- the UPS is providing power to battery power-supplied outlets from its battery. System Overload- Occurs when connected equipment exceeds the rating of unit. Turn the UPS off, unplug at least one piece of equipment, wait 10 seconds, reset the circuit breaker and turn the unit on. Battery Overload- Occurs when connected equipment exceeds the rating of battery outlets of the unit. Turn the UPS off, unplug at least one piece of equipment from battery outlets, wait 10 seconds, reset the circuit breaker and turn the unit on. Electrical Wiring Fault- This indicates a wiring problem with the AC outlet such as bad ground, miss ground, or reversed wiring. User is advised to disconnect all electrical equipment from the outlet and have an electrician check the outlet to insure proper wiring. 7 TROUBLESHOOTING Problem Full-time surge protection outlets stop providing power to equipment. Wait 10 seconds, reset the circuit breaker by depressing the button, and then turn the UPS on. [. . . ] Damage from causes other than AC Power Line Transients, spikes, or surges on properly installed, grounded and code-compliant 120 volt power lines in the United States and Canada; transients, surges, or spikes on standard telephone land lines, PBX telephone equipment lines or Base 10/100T Ethernet lines, when properly installed and connected. (This exclusion applies, for example, to fluctuations in data transmission or reception, by CATV or RF transmission or fluctuations, or by transients in such transmission). Damage from any circumstance described as excluded above with respect to the Product. Damages from fire, flood, wind, rain, rising water, or leakage or breakage of plumbing; from abuse, misuse, or alteration of either the Product or the Connected Equipment. 3. [. . . ]