User manual CULLIGAN PREFERRED 350 DRINKING WATER FILTERS

[. . . ] D 01/06/03 DCO# 5378 Culligan® PreferredTM Series Drinking Water Filters Installation, Operation, and Service Guide SPECIFICATIONS Operating Pressure Range: 10 - 125 psi (0. 7 bar - 8. 6 bar) Operating Temperature Range: 35 - 100°F (2 - 38°C) Service Flow Rate: 0. 5 gpm (1. 9 Lpm) Capacity: 750 gal. (1, 135L) Preferred 350 For cold water use only NSF/ANSI 42 NSF/ANSI 53 4" (10. 7 cm) Dia. Unit Dimensions with · Preferred 150 Cartridge 12-3/4" (32. 4 cm) · Preferred 250 Cartridge 17-3/4" (45. 1 cm) · Preferred 350 Cartridge 20" (50. 8 cm) CERTIFICATION PROGRAM ANSI ACCREDITED NSF's Certification Program is accredited by the American National Standards Institute NSF's Certification Program is accredited by the Dutch Council for Accreditation System Tested and Certified by NSF International against NSF/ANSI Standards 42 and 53 for the reduction of: Standard No. [. . . ] Refer to Figure 2 to determine the best filter bracket position to accommodate the water connections. Install the 0. 5 gpm flow restrictor fitting into the outlet port on the filter head using Teflon tape. Install the remaining 1/4 inch tubing fitting into the filter head inlet using Teflon tape. Connect the inlet and outlet tubing to the inlet and outlet fittings of the filter. Double check the water connections to be sure that water will follow the direction-of-flow arrow on top of the head; water supply to inlet fitting, outlet fitting to faucet. 10. Flush the cartridge for three minutes to purge the system of air. Validated by WQA according to NSF/ANSI 42 and 53 for the claims listed by NSF International as verified and substantiated by test data. Check for compliance with state and local laws and regulations. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts. Note that some states require licensed installers, and some states prohibit the use of saddle valves. INSTALLATION Culligan recommends that Preferred Series Drinking Water Filters be installed with a faucet dedicated to dispensing only filtered water. Refer to the plumbing schematic shown in Figure 1 when completing this type of installation. Other recommended applications include point-of-use drinking water coolers, refrigerators, and ice makers. *Not tested or certified by NSF. Head can be rotated a maximum of 45° from wall. FILTER REPLACEMENT 45° Illustration A Right Wall Mounting These drinking water systems must be maintained according to the manufacturer's instructions, including timely replacement of filter cartridges. Follow the guidelines below to determine when the filter cartridge must be replaced in each system. [. . . ] Holding head firmly, press cartridge fully into head. Replaceable components and service parts are available through your local independent Culligan dealer. Turn water on and run water for 3 minutes to purge cartridge of air. Manufactured by: CULLIGAN INTERNATIONAL COMPANY One Culligan Parkway Northbrook, IL 60062 USA (847) 205-6000 http:\\www. culligan. com Figure 3 ©2002 Culligan International Company [. . . ]