User manual CULLIGAN MEDALLIST PLUS AUTOMATIC WATER CONDITIONER 30 MODEL

[. . . ] The Culligan Medallist Series® 8 Water Softeners are tested and certified by WQA against NSF/ANSI Standard 44 for the effective reduction of hardness (calcium and magnisium) and barium/radium as verified and substantiated by test data. The Culligan Medallist Plus Series® 30, 45 and 60 Water Softeners are tested and certified by WQA against NSF/ANSI Standard 44 for the effective reduction of hardness (calcium and magnesium) and barium/radium as verified and substantiated by test data. The Culligan Medallist Plus Series® 30, 45 and 60 Water Softeners are tested and certified by WQA against NSF/ANSI Standard 61 for material requirements. for installations in Massachusetts , Massachusetts Plumbing Code 248 CMR shall be adhered to. [. . . ] If "dIP 2" is set to "Id", the unit will begin a regeneration immediately for instances 1 and 2. With "dIP 2" set to "del", the regeneration will not begin until the preset regeneration time. note: The to immediate mode as timeclock or timeclock the cover plate. Note: If setnipple must extend no more than 1 inch abovebackup, the unit will initiate regeneration at 12:00 AM. Direct the drain line discharge into a bucket where flow can be observed. plug the transformer into a 120 Volt , 60 Hz , single-phase receptacle. Initiate an immediate regeneration to move the control into the backwash position. refer to the section on manual cycling for information on cycling the control through its positions. When in the backwash position, slowly shift the bypass to the soft water position until water flows. Increase the flow again when resin no longer appears in the discharge. When the unit is filled with water, return the timer to the service position and proceed with setting the microprocessor. Note: Unplugging the Culligan® Medallist Series water softener will not affect any of the control settings. Salt is the Inside Textmineral used to "recharge" your water conditioner. A brine solution is automatically made up in the bottom of the salt storage container, the Cullex® resin beads in the tall, thin tank are flushed with brine solution as a step in the recharging process. Your Culligan Water Conditioner has been carefully designed to get the greatest amount of softening capacity from the salt it uses. Here is some pertinent information about salt usage, types and service. This control is set at the time of installation, and determines salt usage according to the water hardness, number of persons in the household, and water usage. All Culligan Water Conditioners are designed to use any water conditioner salt of good quality, including "rock", "pellet", "solar", or "evaporated" types. All rock salt, regardless of source, contains insoluble material which collects at the bottom of the salt storage tank and requires periodic clean-out. Regardless of what type of salt is used, we recommend Culligan Brand Salt as suggested by your Culligan Dealer. He is the expert and can provide you with the best product for your Culligan Water Conditioner. Whether you have automatic delivery service or pick up salt from your Culligan Dealer, you will be getting quality salt packaged according to rigid Culligan specifications. [. . . ] It is advisable to have the salesperson or installer fill in the information below for your future reference. If this has not been done, please ask for it, as it is necessary if you contact your dealer. Regeneration Interval ________________ days (Time clock models) Gallons to signal ________________ gallons (Soft-Minder® models) Number of people in household ___________________________________________________________ ___ As an expression of our confidence in Culligan International Company products, your water conditioner is warranted to the original end-user, when installed in accordance with Culligan specifications, against defects in material and workmanship from the date of original installation, as follows: For a period of ONE YEAR For a period of FIVE YEARS For a period of TEN YEARS The entire conditioner The AccuSoft® circuit board, or Soft-Minder® meter, if so equipped The control valve body, excluding internal parts The conditioner tank The salt storage container, brine valve and all its component parts The Cullex® resin original consumer purchaser If a part described above is found defective within the specified period, you should notify your independently operated Culligan dealer and arrange a time during normal business hours for the dealer to inspect the water conditioner on your premises. Any part found defective within the terms of this warranty will be repaired or replaced by the dealer. [. . . ]