User manual CUISINART WCH-850

[. . . ] A loose fit between the AC outlet (receptacle) and plug may cause overheating and a distortion of the plug. This appliance is designed to be freestanding only, and should not be recessed or built in (fully recessed). Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc. ). Direct sunlight will affect/alter the outside color of the appliance. 16. [. . . ] Hold filter upright, under water, and gently agitate it for 1 or 2 minutes or until you stop seeing bubbles rising to surface. Lift the flip top lid, and using a clean pitcher, pour cold tap water into the unfiltered/ upper water tank until full. Allow approximately 15 minutes for water to filter into the filtered/lower water tank. NOTE: Tank must be at least ½ full before proceeding to Step #3. To allow internal cold water tank to fill, place glass under spigot and press and hold Cold button until water flows steadily (about 1 minute). NOTE: Until air is fully displaced by water, water flow will be a little erratic. The blue light around the power switch indicates the unit is on and the cold feature is activated. Dispense 16 ounces of room temperature water to remove any unfiltered water. After approximately 1 hour the blue cold water indicator will light up signaling the water has chilled. NOTE: On subsequent fill-ups, unit may take up to 30 minutes to chill. Using the Filter Timer It is important to change your water filter regularly to enjoy the full benefits of good tasting filtered water. The filter timer automatically reminds you when your water filter should be changed. For optimum results, it should be changed every 3 to 4 months, or 80 gallons. Once the filter is in place and unit assembled, start the filter timer as follows: 1. On the cover, there is a filter timer that lets you know when to replace the filter. Press and hold the Start button until the word "Filtering" is displayed (approximately 3 seconds). We recommend replacing the filter with a new Cuisinart® Water Filter within the following 2 weeks, depending on usage. NOTE: Only the Cuisinart Replacement Filter (see next page) can be used with this unit. 5. Once you replace the filter, reset the timer by pressing the Start button. NOTE: If you do not replace the filter and press and hold Start button for 3 seconds, the timer will automatically shut off for power save and no display will be shown. You can press and hold Start button for 3 seconds anytime to reset the timer if needed. If you press Start button for more than 5 seconds the timer will automatically shut off for power save. TIPS AND HINTS · Drinking 4 to 8 glasses of water each day is healthy!· Regular use of clean, filtered water in your automatic coffeemaker means less frequent decalcification treatments. [. . . ] Cuisinart and not the consumer will be responsible for the reasonable cost of such service, repair, replacement, or refund for nonconforming products under warranty. California residents may also, according to their preference, return nonconforming products directly to Cuisinart for repair, or if necessary, replacement, by calling our Consumer Service Center toll-free at 1-800-726-0190. Cuisinart will be responsible for the cost of the repair, replacement, and shipping and handling for such products under warranty. BEFORE RETURNING YOUR CUISINART® PRODUCT If you are experiencing problems with your Cuisinart® product, we suggest that you call our Cuisinart® Service Center at 1-800-7260190 before returning the product serviced. [. . . ]