User manual CUISINART WCH-1500

[. . . ] INSTRUCTION BOOKLET ® Cuisinart® Countertop Filtration System WCH-1500 For your safety and continued enjoyment of this product, always read the instruction book carefully before using. When using an electrical appliance, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury, including the following: 1. Other uses not recommended may cause fire, electric shock or personal injury. To protect against electric shock, do not immerse unit, plug or cord in water or spray with liquids. Close supervision is necessary when any appliance is used by or near children. [. . . ] To resume your hot water, simply put the Energy Saver switch in its Off position. After about 15 minutes, the red LED hot water indicator will light up, signaling hot water is ready to dispense. NOTE: If your unit has been in Energy Saver mode for longer than a week, we recommend you flush out your hot water tank by dispensing and disposing of a full glass of water from the left spigot before enjoying your first glass of hot water. 2. Repeat process with ROOM button, and then with the HOT button until all flow steadily. NOTE: When filling hot and cold internal tanks, the water level in the lower tank will drop and you will hear the filling process taking place. Setting the Filter Timer The filter timer, located on the lid of the unit, lets you know when to change your water filter. Once unit is set up and all water tanks are full, peel off the "Filtering" sticker from the filter timer screen. For best results, we recommend inserting a new Cuisinart® Water Filter immediately. You may turn off the timer and display by pressing the Start button for 5 seconds. Once you replace the filter, reset the timer by pressing the Start button for 3 seconds. NOTE: You may reset the timer at any time by pressing and holding the Start button for 3 seconds. OPERATING INSTRUCTIONS Once set up is completed, tanks are filled and water is flowing steadily, your unit is ready to use!The BLUE light around the power switch indicates the unit is on and cooling and heating functions are activated. After about 15 minutes, the RED hot water indicator will light up, signaling hot water is ready to dispense. REPLACING WATER FILTER Replacement filters may be purchased at most retail outlets or www. cuisinart. com. To replace your filter, follow "Water Filter Setup" on page 4. TIPS AND HINTS · Drinking 4 to 8 glasses of water each day is healthy! · Regular use of cleaner, filtered water in your automatic coffeemaker means less frequent decalcification treatments. · Cleaner, filtered water makes tea and instant soup or coffee taste better. · Keeping the upper tank full helps increase the filtering process as well as the flow rate of water from spigots. · Proper setup of the filter (as instructed on page 4) will maximize the reduction of contaminants and optimize taste of water. · You may notice some condensation and water droplets on the lid and tanks of your unit. There is no water in tanks. TROUBLESHOOTING Symptom Possible Cause Solution 1. Make sure air has been purged from internal tanks, as stated on page 5. If there is water in the tanks, it will take about 80 minutes for the water to chill the first time. [. . . ] We warrant that your Cuisinart® Countertop Filtration System will be free of defects in materials and workmanship under normal home use for 3 years from the date of original purchase. We suggest you complete and return the enclosed product registration card promptly to facilitate verification of the date of original purchase. However, return of the product registration card does not eliminate the need for the consumer to maintain the original proof of purchase in order to obtain the warranty benefits. In the event that you do not have proof of purchase date, the purchase date for purposes of this warranty will be the date of manufacture. [. . . ]