User manual CUISINART SS-1

[. . . ] INSTRUCTION BOOKLET Cup-O-MaticTMCoffeemaker SS-1 For your safety and continued enjoyment of this product, always read the instruction book carefully before using. IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and/or injury to persons, including the following: 1. READALLINSTRUCTIONS. To protect against electric shock, do not place cord, plug, or base in water or other liquids. Close supervision is necessary when any appliance is used by or near children. Allow to cool before putting on or taking off parts and before cleaning the appliance. [. . . ] NOTE: Be sure not to press the BREW button first, as this may initiate the brewing mode. NOTE: If the brew cup is partially inserted, the unit will beep and the power button will fast flash. When the boiler has been primed the unit will automatically begin heating. The Power button will flash and the Default/Lastselected setting buttons will be illuminated. When the unit is heated the Power button and Default/Last-selected buttons will be illuminated. From standby you can change settings, or initiate brewing or cleaning modes. MAKINGCOFFEE 1. Insertthewaterfilter. Remove the filter from polybag and soak in cold tap water for 15 minutes. Remove the water filter holder from the coffeemaker by lifting it out of the reservoir area with your thumb and forefinger. Using the thumb of the other hand, gently press down and pull towards you. Place the filter in the holder and close the water filter holder; you will hear a snap indicating filter is in place. NOTE:Cautionmustbeusedwheninserting thecharcoalfilter. Improperplacementin theholdercancausetearingofthefilter skin. You should place the hole openings in the side of the holder directly under the water stream. Replace the water filter holder in the reservoir area of the coffeemaker, pushing it all the way down to the base of the unit, along the reservoir wall. NOTE:We recommend changing the water filter every 60 days or more often if you have hard water. Replacement water filters can be purchased in stores or by calling customer service or through the Cuisinart website. 2. NOTE: The settings from your last cup of coffee will remain selected until a) the unit is unplugged or b) new settings are selected. If the unit has been unplugged between uses, the unit will reset to the default settings (POD/ REG/6 oz). tarttheBrewCycle S When your Cup-O-MaticTM coffeemaker has reached the correct temperature the Power light will stop flashing. The Power and Default/Last-selected Setting buttons will be illuminated. Check to make sure your preferred type, strength and amount of coffee are selected, and place your cup/mug on the drip tray. You will not be able to change your settings once the unit is brewing. NOTE: To accommodate the Cuisinart travel mug (or other tall cups) remove the drip tray. fterBrewing A When the brewing cycle is completed, 5 beeps will sound. [. . . ] However, return of the product registration card does not eliminate the need for the consumer to maintain the original proof of purchase in order to obtain the warranty benefits. In the event that you do not have proof of purchase date, the purchase date for purposes of this warranty will be the date of manufacture. If your Cuisinart® Cup-O-MaticTM should prove to be defective within the warranty period, we will repair it, or if we think necessary, replace it. To obtain warranty service, simply call our toll-free number 1-800-726-0190 for additional information from our Customer Service Representatives, or send the defective product to Customer Service at Cuisinart, 150 Milford Road, East Windsor, NJ 08520. [. . . ]