User manual CUISINART DTC-850BK

[. . . ] Prior to connecting or disconnecting plug from wall outlet, turn all controls to "OFF". WARNING: To reduce risk of fire or electrical shock, do not remove bottom cover. It must never be used with any other drip-type coffee maker, or on a range top or in a microwave oven. Do not use a cracked thermal carafe or a thermal carafe that has a loose or weakened handle. [. . . ] When complete, press the "prog" button, or wait for 15 seconds and your set time will be accepted. To Activate the Auto Brew Cycle To activate the auto brew mode, depress the "auto on" button. The "auto" symbol will illuminate in the upper right hand corner of the LCD screen. When the programmed time initiates the cycle, the red "ON" indicator light will show that the brewing cycle has started. NOTE: The unit will continue to attempt to brew at the programmed time, each day, until the Auto On button is turned off. The red "ON" indicator light will illuminate each time the attempt to brew is made. If there is no water in the reservoir, the unit will automatically shut off one minute later. cover; pour water into reservoir opening. Markings on water level indicator show amount of water needed to make desired number of cups of coffee. Before thermal carafe is returned to platform, prewarm carafe by running warm water through carafe. If warm water is not run through carafe, when hot coffee flows into carafe during brewing cycle the glass liner may crack due to the temperature change. Prewarming carafe will help keep coffee warmer, and also prevent glass liner from being damaged. To close lid, turn it in direction of "CLOSE" arrow until it fits tightly on carafe, and "POUR" arrow is aligned with spout. Be certain thermal carafe lid is in "CLOSED" position and is securely in place during brew cycle. Insert a filter into filter basket; make sure filter fits snugly in basket. After placing 2 level tablespoons per cup of ground coffee into cone filter, return basket to closed position. With thermal carafe and basket securely in place, press "ON" button; LED will light. CAUTION: Coffee maker becomes very hot during brew cycle; handle with extreme care as hot parts and escaping steam may cause burns. The Brew-Through lid allows coffee to drip from coffee maker through closed lid. When coffee has completely stopped dripping into thermal carafe and water level indicator is empty, brew cycle is complete. When dripping stops, Brew-Through lid will seal so coffee freshness and temperature are preserved. An audible "beep" tone will signal when brew cycle is complete. After coffee grounds have cooled, carefully open filter basket and discard used coffee filter COFFEE PREPARATION 1. [. . . ] Some states do not allow the exclusion of or limitation of incidental or consequential damages, so the foregoing limitation or exclusion may not apply to you. CALIFORNIA RESIDENTS ONLY California law provides that for In-Warranty Service, California residents have the option of returning a nonconforming product (A) to the store where it was purchased or (B) to another retail store which sells Cuisinart® products of the same type. The retail store shall then, at its option, either repair the product, refer the consumer to an independent repair facility, replace the product or refund the purchase price less the amount directly attributable to the consumer's prior usage of the product. If either of the above two options does not result in the appropriate relief to the consumer, the consumer may then take the product to an independent repair facility if service or repair can be economically accomplished. Cuisinart, and not the consumer, will be responsible for the reasonable cost of such service, repair, replacement or refund for nonconforming products under warranty. [. . . ]