User manual CUISINART DGB-600BC

[. . . ] Grind & Brew ThermalTM 10-Cup Automatic Coffeemaker DGB-600 For your safety and continued enjoyment of this product, always read the instruction book carefully before using. IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and/or injury to persons, including the following: 1. To protect against electric shock, do not place cord, plug, or base unit in water or other liquids. Close supervision is necessary when any appliance is used by or near children. Allow to cool before putting on or taking off parts and before cleaning the appliance. [. . . ] When scrolling, the numbers will advance slowly at first and then speed up to the rate of about three per second. When the number displayed approaches the desired setting, release the button and press repeatedly to advance one digit at a time. Be careful to make sure that the PM indicator is on if a PM time is desired. Exiting "Time Set" Mode: "Set Program Time" may be exited in any of three ways: 1. Press any other button (except "Hours" or "Minutes"). "Set Program Time" will be exited and the function of that button will be executed. If neither the "Hours" nor "Minutes" button is pressed for a period of five seconds, the "Set Program Time" mode will be exited and the programmed setting will be in effect. The "Time Set" mode can be exited in one of two ways: 1. Press any button besides the "Hours" or "Minutes" button. This will exit the "Time Set" and activate the selected function. If neither the "Hours" nor "Minutes" button is pressed for a period of five seconds, the "Time Set" mode will be exited. Insert the Water Filter a. Remove the filter from polybag and soak in cold tap water for 15 minutes. b. Remove the water filter holder from the coffeemaker by lifting it out of the reservoir area with your thumb and forefinger. d. Place the filter in the holder and close the water filter holder; you will hear a snap indicating filter is in place. Improper placement in the holder can cause tearing of the filter skin. e. Hold the filter under cold running tap water for 10 seconds to flush. You should place the hole openings in the side of the unit directly under the water stream. Setting the Program Time: When you press the "Program Set" button, it displays the current program time (default time 12:00 p. m. ). Entering "Set Program Time" Mode: Press and hold the "Program Set" button (about 2 seconds) until the green light and LCD display begin to flash. This signals that you have entered the "Set Program Time" mode. The desired time can be set by pressing the "Hours" and "Minutes" buttons to scroll forward through the digits. Fill the Water Reservoir Open the reservoir lid by pushing the release button and lifting up. Pour the desired amount of water in the reservoir using the step water indicator located at the rear of the reservoir. Add Beans Lift the grinder basket lid, using the recess on either side. Do not overfill or the grinder could malfunction and/or the coffeemaker may overflow. [. . . ] For best performance from your coffeemaker, decalcify the base unit from time to time. The frequency depends upon the hardness of your tap water and how often you use the coffeemaker. To clean, fill the water reservoir to capacity with a mixture of 1/3 white vinegar and 2/3 water. When the cycle is completed and the five beeps sound, turn coffeemaker off. [. . . ]