User manual CUISINART DCC-1000

[. . . ] Programmable Filter BrewTM 12-Cup Coffeemaker DCC-1000 IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and/or injury to persons, including the following: 1. To protect against electric shock, do not place cord, plug, or base unit in water or other liquids. Close supervision is necessary when any appliance is used by or near children. Allow to cool before putting on or taking off parts and before cleaning the appliance. [. . . ] Gold Tone Filter (not shown) 4 1 2 4 8 7 9 10 11 13 14 5 CONTROL PANEL 1 of day, auto on time and auto off time. On and Auto On Indicator Lights PROGRAMMING YOUR COFFEEMAKER 3 2e 2 2d 2f 1. Turn on: To turn coffeemaker on, turn the function knob to the "On" position. The red "On" indicator light illuminates and brewing cycle starts. Push and hold or pulse the "Hour" or "Minute" buttons to set the time of day. Turn the function knob to any other setting to begin time, or simply wait until the numerals stop blinking. "Hour" Button: To change the hour, press the "Hour" pushbutton. Pressing and holding the pushbutton will cause hours to increase more rapidly. When the number count passes 12, the PM light activates and will be displayed on the LCD. "Minute" Button: To change the minute, press the "Minute" pushbutton. Pressing and holding the pushbutton will cause minutes to increase more rapidly. Note: As you scroll, the numbers will advance slowly at first and then speed up to the rate of about three per second. When the number displayed approaches the desired setting, release the button and press repeatedly to advance one digit at a time. Press and hold the "Hour" button for five seconds, until the clock display starts blinking. To change the hour and minutes, use the pushbuttons as you would to set the time of day. The Auto Off time can be set from zero to four hours in minute increments. If no auto off time is set, the coffeemaker will turn off after two hours. MAKING COFFEE Before making the first pot of coffee in your new Cuisinart® Filter BrewTM Deluxe Coffeemaker, we recommend operating the coffeemaker once using only water and a filter paper. This will remove any dust or residues in the system that remain from the manufacturing process. 1. Remove the filter from polybag and soak in cold tap water for 15 minutes. Remove the water filter holder from the coffeemaker by lifting it out of the reservoir area with your thumb and forefinger. Hold the water filter holder lengthwise and place thumbs in slots directly under arrows. Place the filter in the holder recess area at the bottom of the water filter holder. [. . . ] Place the new filter in the holder recess area at the bottom of the water filter holder. Close the water filter holder; you will hear a snap indicating it is in place. You should place the hole openings in the side of the unit directly under the water stream. 8 i. Replace the water filter holder in the reservoir area of the coffeemaker, pushing it all the way down to the base of the unit. WARRANTY THREE-YEAR LIMITED WARRANTY This warranty supersedes all previous warranties on the Cuisinart® Programmable Filter BrewTM 12-Cup Coffeemaker. [. . . ]