User manual CUISINART CPC-600

[. . . ] Do not let cord hang over edge of table or counter, or touch hot surfaces. Use of accessories not specifically recommended by Cuisinart may cause damage to unit. Do not use under hanging cabinets; steam from pressure release may cause damage. Always attach plug to appliance first, before plugging into wall outlet. [. . . ] The choice will be dictated by the particular food being cooked and indications in the recipe. If adapting your own recipe for pressure cooking, find a similar recipe in our recipe booklet and use that as a guide. Natural Pressure Release ­ Following pressure cooking, allow the unit to remain on Keep Warm. The pressure will begin to drop ­ time for pressure to drop will depend on the amount of liquid in the pressure cooker and the length of time that pressure was maintained. During this time cooking continues, so it is recommended for certain cuts of meats, and some desserts. When pressure is fully released, the float (pressure indicator) will drop and the lid will unlock to open. Quick Pressure Release ­ Following pressure cooking you will hear a series of beeps indicating the process is finished. Turn off and pull the handle of the pressure limit valve forward (see figures 6 and 6a). Place the pressure cooker on a clean, flat surface where you intend to cook. Place the condensation collector in rear of the unit until it clicks into place (as shown below; also see #6 on diagram, page 3). Condensation Collector 3. To lock the lid in place, remove any food residue from upper rim of cooking pot to ensure a proper seal. Make sure sealing ring is securely in place on sealing ring supporting cover (figure 3). Hold knob on sealing ring supporting cover and press firmly over the center post of inner lid to secure (figure 4). Place lid on pressure cooker and turn it counterclockwise into position. (3) (4) Note: When placing lid on pressure cooker, the float valve should be facing the left. Position the pressure limit valve as directed in figure 5 and 5a, ensuring it is set to the · position. The float in handle must be fully down to properly seal the pot before cooking. 3. Place the pressure limit valve on the lid, as shown in figures 5 and 5a. Even though it will have a loose fit, it is safely secured. (6) (6a) INSTRUCTIONS FOR USE Once the pressure cooker is assembled properly, you are ready to begin pressure cooking. Remove cooking pot from pressure cooker and add food and liquids as the recipe directs. Plug the power cord into the pressure cooker and then into the wall outlet. The LED display will show . Steam will immediately begin to release through the valve. Keep face and hands away from steam as it is released, and do not release pressure under hanging cabinets, which can be damaged by steam. [. . . ] This warranty expressly excludes any defects or damages caused by accessories, replacement parts, or repair service other than those that have been authorized by Cuisinart. This warranty does not cover any damage caused by accident, misuse, shipment or other ordinary household use. Some states do not allow the exclusion or limitation of these damages, so they may not apply to you. CALIFORNIA RESIDENTS ONLY: California law provides that for In-Warranty Service, California residents have the option of returning a nonconforming product (A) to the store where it was purchased or (B) to another retail store which sells Cuisinart products of the same type. [. . . ]