User manual CUE RFCUE 99

[. . . ] 7 Button Labels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Addressing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Modify Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 7. 2. [. . . ] Connect the charger to the rfCUE 99 also in case you find the lower range of the transmission or when the back-light brightness is reduced. 1 5 2 6 3 7 4 8 9 13 17 21 10 14 18 22 11 15 19 23 12 16 20 24 25 29 26 30 27 31 28 32 User Manual rfCUE www. cuesystem. com Page 7 of 18 5. Button Labels The labeling is provided by a plastic foil inserted under the buttons. Use AutoCAD file named CS0170. 0007. 1-Foil. dwg for preparation of a layout. Remove the front panel with buttons and foil still holding it upside down. Fasten the screws. User Manual rfCUE www. cuesystem. com Page 8 of 18 6. Different address setting in time of delivery is available on request. The address of the rfCUE 99 can be in set in the range 0 to 9 and can be changed in the rfCUE 99 modify mode - see chapter Modify Mode. When the address is set to 1 the button codes are in range 33 to 64, for address 2 the button codes are in range 65 to 96 and so on. Generally speaking the button codes of the rfCUE 99 are dependent on the address and can be calculated according formula BUTTON_ID Offset = Offset + Button Code = 32 * ADDRESS The lowest BUTTON_ID is generated by a button in the upper left corner the highest BUTTON_ID is generated by a button in the lower right corner. ADDRESS = 0 ADDRESS = 1 ADDRESS = 9 1 5 9 13 17 21 25 29 2 6 10 14 18 22 26 30 3 7 11 15 19 23 27 31 4 8 12 16 20 24 28 32 33 37 41 45 49 53 57 61 34 38 42 46 50 54 58 62 35 39 43 47 51 55 59 63 36 40 44 48 52 56 60 64 289 290 291 292 293 294 295 296 297 298 299 300 301 302 303 304 305 306 307 308 309 310 311 312 313 314 315 316 317 318 319 320 User Manual rfCUE www. cuesystem. com Page 9 of 18 7. Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Before starting, please check first if you have all the following items 1. The program RFMOD. EXE makes the rfbaseCUE send via RF a special command, which will set the receiving rfCUE to modify mode. To send this command can be also achieved directly from the rfbaseCUE service mode ­ see User Manual rfbaseCUE. The rfCUE is able to receive this command only when back-light button is pressed. 7. 2. How to Display the Address . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Steps are 1. Disconnect RS-485 signals A and B on the rear panel of the rfbaseCUE, connect the power. Connect your PC to the rfbaseCUE HOST connector using a data communication cable. Run the RFMOD. EXE (in DOS window) still holding the back-light button. The rfCUE 99 will return to normal operation with new address after releasing the back-light button. User Manual rfCUE www. cuesystem. com Page 11 of 18 8. When pressing the button the LEDs are going on and off immediately and then back-light button flashes several times. The increased consumption causes a drop of voltage, which then resets the microprocessor. · Check the presence of disturbing RF signals (frequencies of other RF operating equipment in the installation). · Change position of rfbaseCUE antennas. User Manual rfCUE www. cuesystem. com Page 12 of 18 9. [. . . ] o. , Na Dolinách 6, Praha 4, Czech Republic acknowledge our sole responsibility, that the product incl. accessories Kind of equipment Remote Control System Type designation CS0197 touchCUE-L 99, CS0159 touchCUE 99, CS0157 touchCUE-S 99, CS0183 touchCUE-V, CS0198 touchCUE-L, CS0200 touchCUE-M, CS0176 touchCUE-MM, CS0122 touchCUE, CS0142 touchCUE-S, CS0178 touchCUE-V /t, CS0199 touchCUE-L /t, CS0204 touchCUE-M /t, CS0143 touchCUE-S /t, CS0158 touchCUE-S /w, CS0224 touchCUE-S /d, CS0205 touchCUE-M /r, CS0144 touchCUE-S /r ST0007 Guide, CS0188 touchCUE-SRF, CS0171 rfbaseCUE, ST0013 monitorCUE-V, CS0203 monitorCUE, CS0190 touchCUE-V /i, CS0151 PC Interface 485 CS0170 rfCUE 99, CS0170 rfCUE 99, CS0149 irCUE 99, CS0133 irCUE, CS0080 irCUE Receiver, CS0169 irCUE Receiver 485, CS0221 keypadCUE-1G, CS0222 keypadCUE-2G, CS0223 keypadCUE-3G, CS0145 keyboardCUE 99, CS0128 keyboardCUE, CS0174 keyboardCUE-S, CS0129 keyboardCUE /t, CS0146 keyboardCUE-S /w, CS0130 keyboardCUE /r, CS0191 inputCUE, CS0173 eCUE CS0051 Assistant, CS0150 Assistant-S, CS0100 PC Card, CS0227 CUEwire Splitter, CS0008 smartCUE, CS0201 sbiCUE-DMX, CS0009 soundCUE, CS0004 analogCUE, CS0005 auxCUE, CS0165 PED202, CS0166 PEF200, CS0167 PER610, CS0163 PEC25, CS0225 PEA208, CS0164 PED108, CS0184 CUEadapter /10W, CS0226 CUEadapter /20W, CS0185 CUEadapter /50W, CS0186 CUEadapter /80W, CS0168 PES03, CS0016 powerAUX, PT0005 Cue Director, PT0004 Teach-In, PT0006 WinKit in accordance with EMC Directive 89/336/EEC, is in compliance with the following norms or documents: EN50082-1 (IEC801-2), IEC65(CO)39, DIN VDE 0839 part 82-1, DIN VDE 0843 part 4, IEC801-4, EN50081-1 EN55022 class B, DIN VDE 0839 part 81-1, EN55014, EN55011. Jaroslav Dibitanzl Member of Board of Directors User Manual rfCUE www. cuesystem. com Page 16 of 18 13. FCC Caution Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]