User manual CUE KEYPADCUE-8-L

[. . . ] Addressing buttons of keypadCUE-8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 4. 1. 1. Addressing rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 4. 1. 2. Setting-up keypad buttons ADDRESS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 4. 1. 3. Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 4. 2. [. . . ] Be as precise as possible, because it is very difficult to remove the panel once it has been glued. User Manual keypadCUE-8 www. cuesystem. com Page 7 of 20 3. 2. Button labels for keypadCUE-8-L For keypadCUE-8-L, two types of custom labels can be used. Paper labels can be used temporarily during trial operation (or for permanent installation in technical areas where design is not critical). For final installation, have labels engraved upon the organic glass. 3. 2. 1. Recommended fonts are Nimbus, Trebuchet, Verdana or Arial, size 9 points, bold. 12, 60 27, 20 27, 20 106, 80 27, 20 All dimensions are in mm 2. In doing that, insert the transparent cover under one side of the keypad and bend it slightly until it is possible to insert the other side of the cover as well. User Manual keypadCUE-8 www. cuesystem. com Page 8 of 20 3. When changing the label, it is necessary to remove the transparent cover carefully. Insert the screwdriver into the small slot in the bottom part of the cover. Bend the middle part of the cover carefully until the cover is released on one side. Have the labels engraved on the rear surface of the plastic stripes of the front panel. Recommended fonts are Nimbus, Trebuchet, Verdana or Arial, size 9 points, bold. 2. Place the stripes onto the keypad, using the same procedure as described in the previous chapter (on placing the transparent cover over paper labels). Engraved strips do not have slots for easy removing because of design reasons. If you do need to remove the engraved strip, stick some tool to the centre of the strip using a piece of double-sided foam adhesive tape. Then lift the central part of the strip, insert a screwdriver under it and bend the strip slightly until it is released on one side. Then you can remove the strip. User Manual keypadCUE-8 www. cuesystem. com Page 9 of 20 4. Addressing rules The ADDRESS of the buttons and LEDs of keypadCUE-8 can be set in the range 0 to 207. The BUTTON_ID transmitted by the panel is the LINK number used in the programming for button identification. Both values depend on the button (LED) position and on a keyboard ADDRESS too. BUTTON_ ID BUTTON_LED_ID = (32 * ADDRESS) + Button Code = (32 * ADDRESS) + Button LED Code The lowest BUTTON_ID is generated by the button in the upper left corner; the highest BUTTON_ID is generated by the button in the lower right corner - see example in the picture below. In the table below Button ID range for some addresses is shown. ADDRESS 0 1 2 . . . 6632 User Manual keypadCUE-8 www. cuesystem. com Page 10 of 20 4. 1. 2. Push the keypad button addressing switch on the rear side of keypadCUE-8 by small screwdriver or wire; backlight LEDs are switched off to indicate Set Address Mode. [. . . ] No Other Warranties: CUE DOES NOT WARRANT THAT THE SOFTWARE AND FIRMWARE IS ERROR FREE. CUE DISCLAIMS ALL WARRANTIES WITH RESPECT TO THE SOFTWARE AND FIRMWARE, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OF THIRD PARTY RIGHTS. SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OF IMPLIED WARRANTIES OR LIMITATIONS OF HOW LONG AN IMPLIED WARRANTY MAY LAST, OR THE EXCLUSION OF LIMITATION OF INCIDENTAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM JURISDICTION TO JURISDICTION. [. . . ]