User manual CROWN MA-5000I BROCHURE

[. . . ] Intermodulation Distortion (IMD) (60 Hz and 7 kHz at 4:1, from full rated output to ­30 dB): < 0. 35%. Common Mode Rejection (CMR) (20 Hz to 1 kHz): 55 dB, typically >70 dB. Network: Onboard HiQnetTM, compatible with standard 100 Mb Ethercom hardware. [. . . ] Volume Control: Precision detented attenuator with 31 steps, press-and-hold mute function. Volume Control LED Ring: A ring of green LEDs around each volume control show the position of the control. Can be converted to be a level meter. Network Connector: This Neutrik® Ethercon connector accepts an RJ-45 connector for TCP/IQ or HiQnetTM networking. Next to the connector is a yellow LINK ACT indicator that shows network activity, and a green 100Mb indicator that shows a 100Mb network connection. Data Indicator: Yellow LED on back panel indicates network data activity. Data indicator flashes only when the amplifier is polled for data, or is polled to see whether it is online. Preset Indicator: Green/yellow LED flashes to signal the number of the current preset. LED is green if current preset is active, or is yellow if current preset is modified. Input Sensitivity Switch: Three-position switch providing 1. 4V, 32 dB, and 26 dB settings for both channels. Firmware/Software Firmware can be updated at www. crownaudio. com > Support > Downloads. Software features: User Presets, Clip Event Monitor, Input Signal Level Monitor, Output Signal Level Monitor, Thermal Headroom Level Monitor, Power/ Standby Control, Signal Mute, Polarity Inverter, Input Signal Fader, Dynamic Gain Monitors (Ghost Faders), Amplifier Information, User and Channel Labels, Amplifier Mode, Amplifier Output Mode, Line Voltage Monitor, Error Reporting, Auto Standby, Input Signal Compressor/Limiter, Peak Voltage Limiter, Average Power Limiter, Clip Eliminator, Thermal Limiter, Limiter Tie, Load Supervision. Back Panel Controls, Indicators and Connectors Power Cord Connector: Detachable 20 amp IEC inlet. Reset Switch/Circuit Breaker: If the current draw of the amplifier exceeds safe limits, this breaker automatically disconnects the power supply from the AC mains. Output Connectors: Two high-current, 50A Neutrik® Speakon® NL4MLP (mates with NL4FC or NL4), one per channel. Ch 1 Speakon® is wired with Ch 1 and Ch 2 outputs for use with single 4-conductor cable. Two pairs of high-current, 60A color-coded 5-way binding posts (for banana plugs, spade lugs or bare wire). Analog Input Connectors: A 3-pin female XLR connector for each channel. Analog Loop Thru Connectors: Two male XLR passive analog loop through. [. . . ] See your authorized Crown dealer for full warranty disclosure and details. For customers outside of the USA, please contact your authorized Crown distributor for warranty information or call 574-294-8200. Crown International 1718 W. Elkhart, IN 46517-9439 TEL: 574-294-8200 FAX: 574-294-8FAX www. crownaudio. com Specifications subject to change without prior notice. [. . . ]