User manual CRESTRON TPS-XVGA-BV

[. . . ] This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel Contents RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV 1 Description Functional Description Physical Description Leading Specifications Computer Video Connector Signals Preparation Installation and Hookup Touchpanel Setup Configuring the Touchpanel SIMPLTM Windows® Programming VT Pro-e Setup Problem Solving Troubleshooting Further Inquiries Future Updates Future Firmware Upgrades Appendix: Optional Touchpanel Setups Serial Mouse Control Driver Telestrator Video Annotation Device Return and Warranty Policies Merchandise Returns / Repair Service CRESTRON Limited Warranty 1 1 2 4 5 5 7 13 13 13 13 14 14 15 15 15 16 16 17 18 18 18 Operations & Installation Guide - DOC. 5920 RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV · i Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV Description Functional Description The TPS-XVGA-BV RGB computer interface card with balanced video is an optional feature designed for Crestron's IsysTM TPS-5000 and TPS-6000 tilt touchpanels. Through an RGB window on a page within the uploaded VisionToolsTM Pro-e (VT Pro-e) touchpanel project, the card allows computer video to be displayed on the touchpanel full screen or in a window. [. . . ] Align the pins on the touchpanel interface connector of the card with the touchpanel motherboard connector. Make sure that the screw holes of the card align with the mounting posts on the motherboard. 10 · RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV Operations & Installation Guide - DOC. 5920 Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel Installation Diagram 5 of 7 - Install TPS-XVGA-BV 12. Install the four card mounting screws (supplied), tighten to finger-tight then, using a #1 Phillips screwdriver, tighten an additional 1/8-turn. Installation Diagram 6 of 7 - Install TPS-XVGA-BV Mounting Screws Operations & Installation Guide - DOC. 5920 RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV · 11 RGB Computer Interface Card for TPS/Tilt Panel Crestron TPS-XVGA-BV 13. Hold the touchpanel base cover in place and position the touchpanel face-down onto a padded surface to prevent scratching of the screen. Re-install the eight base cover screws to finger-tight then, using a #1 Phillips screwdriver, tighten an additional 1/8-turn. NOTE: The TPS-IMC, optional TPS-IMW, and TPS-IMC-BV serve as an interface between the touchpanel and the video source computer and/or the Cresnet system. If the touchpanel is equipped with optional TPS-VID Video Card, the audio and video cables from the TPS-IMC to the touchpanel are replaced with the triamese cable. For further information, consult the TPS-IMC-BV Operations Guide (Doc. The latest revision can be obtained from the Products page (PRODUCT MANUALS section) or Downloads page (MANUAL Library) of Crestron's website (www. crestron. com). At the rear of the touchpanel base, attach the triamese cable (supplied) connector labeled AUDIO to the AUDIO port, the non-labeled connector to the RGB port, and the connector labeled NET to the NET/VIDEO port. Installation Diagram 7 of 7 - Attach Triamese Cable Connectors AUDIO CONNECTOR RGB CONNECTOR (NOT LABELED) NET CONNECTOR HEADPHONES AUDIO RS-232 RGB NET/VIDEO LAN 24VDC 2. 0A 17. Re-connect any cables that were disconnected in step 2 to the appropriate ports on the rear of the touchpanel base. If the optional external power pack is utilized with the touchpanel, connect the output plug of the power pack to the 24VDC 2. 0A port on the rear of the touchpanel base. 12 · RGB Computer Interface Card with Balanced Video for TPS/Tilt Panel: TPS-XVGA-BV Operations & Installation Guide - DOC. 5920 Crestron TPS-XVGA-BV RGB Computer Interface Card for TPS/Tilt Panel Touchpanel Setup Configuring the Touchpanel To configure the touchpanel for RGB computer video input, consult the latest revision of the TPS-5000 or TPS-6000 Operations Guide (Doc. The latest version of the Operations Guide can be obtained from the Products page (PRODUCT MANUALS section) or the Downloads page (MANUAL Library) of Crestron's website (www. crestron. com). New users are required to register in order to obtain access to the FTP site. Upon entering the Setup Menu, an RGB button will be available and displayed. Selection of this button opens the RGB Menu from which RGB settings are adjusted. SIMPLTM Windows® Programming No special programming is required in SIMPL Windows for TPS-XVGA-BV operation. NOTE: Join number remapping allows the Isys touchpanel to perform features in a new way. One group of features pertains specifically to use of the RGB Computer Interface Card with Balanced Video. Refer to the latest revision of the Join Number Remapping Reference Guide (Doc. [. . . ] No merchandise may be returned for credit, exchange, or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number, and return address. Products may be returned for credit, exchange, or service with a CRESTRON Return Merchandise Authorization (RMA) number. [. . . ]