User manual CRESTRON TPS-XDS

[. . . ] 7 Return and Warranty Policies. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Merchandise Returns / Repair Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 CRESTRON Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5846 Contents · i Crestron TPS-XDS Docking Station for TPS-XTXRF Docking Station for TPS-XTXRF: TPS-XDS Description Functional Description The TPS-XDS is a docking station designed to power the Crestron IsysTM tilt touchpanel equipped with the optional TPS-XTXRF Two-Way radio frequency (RF) Transceiver Module. [. . . ] If you want to use a power pack other than the Crestron model, verify that it meets the following specifications and polarity. Power Pack Specifications POWER REQUIREMENTS 120VAC 60Hz or 240 VAC 50Hz OUTPUT 24VDC 2A minimum, regulated Power Pack Polarity Leading Specifications The following table provides a summary of leading specifications for the TPS-XDS. Leading Specifications of the TPS-XDS SPECIFICATIONS Dimensions and Weight DESCRIPTION Height: 1. 26 in (3. 19 cm) Width: 10. 89 in (27. 67 cm) Depth: 5. 87 in (13. 34 cm) Weight: 1. 30 lb (0. 535 kg) As of the date of manufacture, the TPS-XDS has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling (N14176). Operations Guide - DOC. 5846 Docking Station for TPS-XTXRF: TPS-XDS · 3 Docking Station for TPS-XTXRF Crestron TPS-XDS Using the TPS-XDS WARNING: To avoid possible physical harm, damage to the TPS-XDS or touchpanel, use only specified external power pack PW-2420RU or equivalent when charging. WARNING: Charge the touchpanel in a well-ventilated area away from sparks and open flame. Do not use the touchpanel near heat sources such as radiators, heat registers, stoves, or other apparatus. CAUTION: Avoid accidental shorting of the electrical contacts to prevent possible damage to the external power pack. If shorted, remove the shorting object(s) and the power pack will automatically reset within 5-10 seconds. NOTE: We recommend that instead of removing power from the TPS-XDS by pulling the power plug out of DC power port, you set the OFF/ON switch on the power pack to OFF. NOTE: Make sure that the TPS-XBTP battery pack is properly installed in the TPS-XTXRF equipped touchpanel. NOTE: Charging of TPS-XBTP is determined by internal temperature, not voltage. The TPS-XBTP/touchpanel will not charge if the internal temperature of the battery pack is too high. Excessive temperature may be produced by high room temperature, heavy usage of the TPS-XVGA/-BV RGB Computer Interface Card and/or TPSVID Video Card, blocked TPS-XTXRF vents, etc. 5845) Operations Guide, Leading Specifications, for the battery operating temperature range. Setup the external power pack according to the Operations Guide provided with the power pack. NOTE: The latest version of the PW-2420RU Power Pack Operations Guide (Doc. 5892) can be obtained from the Downloads | Product Manual section of the Crestron website (www. crestron. com). Place the touchpanel on the TPS-XDS docking area as shown on next page. The electrical contacts are self-aligning with the touchpanel. 4 · Docking Station for TPS-XTXRF: TPS-XDS Operations Guide - DOC. 5846 Crestron TPS-XDS Place Touchpanel on TPS-XDS Docking Station for TPS-XTXRF 1 2 NOTE: The touchpanel may be operated during the charging process but charging time is significantly extended. Depending on touchpanel model, activity, optional expansion cards installed, backlight usage/brightness, etc. , charge time may be from 8-1/2 to 14 hours. 5844) Operations Guide, Leading Specifications for more information on charging times. NOTE: Operating time for an undocked TPS-XTXRF (battery installed) will vary depending on touchpanel model, activity, optional expansion cards installed, backlight usage/brightness, etc. For example, undocked operating time of a TPS-XTXRF equipped TPS-6000 touchpanel with all optional cards and a new, fully charged TPS-XBTP is typically 2-hours before charging is required. 5845), Leading Specifications, for battery charging times. Operations Guide - DOC. [. . . ] Except as expressly set forth in this warranty, CRESTRON makes no other warranties, expressed or implied, nor authorizes any other party to offer any warranty, including any implied warranties of merchantability or fitness for a particular purpose. Any implied warranties that may be imposed by law are limited to the terms of this limited warranty. This warranty statement supercedes all previous warranties. Trademark Information All brand names, product names, and trademarks are the sole property of their respective owners. Windows95/98/Me/XP and WindowsNT/2000 are trademarks of Microsoft Corporation. 8 · Docking Station for TPS-XTXRF: TPS-XDS Operations Guide - DOC. [. . . ]