User manual CRESTRON ST-BTPN

[. . . ] The latest versions of the guides which includes their respective international versions are available from the Downloads | Product Manuals section of the Crestron website (www. crestron. com). Specifications The following table provides specifications for the ST-BTPN. Specifications for the ST-BTPN SPECIFICATION Output Voltage Capacity Composition Estimated Operating Time* Estimated life Optimal Operating Temperature Optimal Storage Temperature Charging Temperature Weight DETAILS 4. 8 VDC 4. 1 Ah, typical Nickel Metal Hydride (NiMH) Up to 5 hours of continuous use (20-22 hours in standby) 500 charge/discharge cycles (min. ) Approximately 50oF to 104oF (10oC to 40oC) Approximately -4oF to 113oF (-20oC to 45oC) Approximately 50oF to 95oF (10oC to 35oC) 0. 79 lb (0. 36kg) *Approximate battery operation for battery pack in touchpanels: Worst case battery operation ­ 3. 0 hours (STX -1700C at full backlight) Best case battery operation ­ 4. 3 hours (ST-1550 at full backlight) Approximate battery charge times in touchpanels: Worst case charge time ­ 6 hours (STX-1700C at full backlight) Best case charge time ­ 2. 7 hours (All units with power off) 2 · Rechargeable Battery Pack: ST-BTPN Operations and Installation Guide - DOC. 6088 Crestron ST-BTPN Rechargeable Battery Pack NOTE: The battery will not charge when above maximum charging temperature. To cool the battery, either turn off power to the touchpanel by pressing the power down button on the touchscreen (or use the power down timeout), or remove the battery from the touchpanel (refer to "Removal" on page 8). [. . . ] Recharge the ST-BTPN after storage prior to use. Operations and Installation Guide - DOC. 6088 Rechargeable Battery Pack: ST-BTPN · 5 Rechargeable Battery Pack Crestron ST-BTPN Charging NOTE: Typically, the battery pack is good for 500 charge/discharge cycles. To charge the ST-BTPN: · Use the powered ST-DSN docking station with battery guide; or · Install the ST-BTPN in a ST-1550C or 1700C and mount touchpanel on a powered ST-DSN docking station. CAUTION: Internal damage to battery pack may occur if it is mounted by itself on the ST-DSN without the battery guide. NOTE: The battery pack may take up to 6 hours to charge in a powered touchpanel. The latest version of the guide is available from the Downloads | Product Manuals section of the Crestron website (www. crestron. com). Installation The unique design of the ST-BTPN prevents it from being installed improperly. The rechargeable battery pack fits only one way in the battery compartment of the touchpanel. Although the ST-BTPN can be installed in several Crestron wireless touchpanel models, the ST-1700C and STX-1700C are the most common models to use the battery pack. Therefore, as an example, the illustration on the next page shows the ST-BTPN properly seated in the ST-1700C. Complete the steps on the next page to install the battery. 6 · Rechargeable Battery Pack: ST-BTPN Operations and Installation Guide - DOC. 6088 Crestron ST-BTPN Rechargeable Battery Pack ST-BTPN installed in a touchpanel (ST-1700C) CRESTRON Crestron Electronics, Inc. Rockleigh, NJ 07647 FCC ID: EROST-1700C SEE MANUAL NOTE: The ST-BTPN is shipped fully discharged. Charge the battery pack in a well-ventilated area away from sparks, flames, or smoking. Place the designated end of the ST-BTPN into the touchpanel battery compartment. Slowly rotate ST-BTPN in compartment so that external face is visible. Verify proper installation with audible click of rechargeable battery pack into battery compartment. Touchpanel latch secures the ST-BTPN and prevents the battery pack from falling out. Operations and Installation Guide - DOC. 6088 Rechargeable Battery Pack: ST-BTPN · 7 Rechargeable Battery Pack ST-BTPN Orientation for Installation Touchpanel latch fits into this cutout Crestron ST-BTPN This side facing out CRESTRON Crestron Electronics, Inc. Rockleigh, NJ 07647 Insert this end of ST-BTPN in touchpanel first Removal Complete the following steps to remove the ST-BTPN from a touchpanel. Lift latch up so that one edge of ST-BTPN pops out of touchpanel battery compartment. [. . . ] Authorized returns must be shipped freight prepaid to CRESTRON, Cresskill, N. J. , or its authorized subsidiaries, with RMA number clearly marked on the outside of all cartons. Shipments arriving freight collect or without an RMA number shall be subject to refusal. CRESTRON reserves the right in its sole and absolute discretion to charge a 15% restocking fee, plus shipping costs, on any products returned with an RMA. Return freight charges following repair of items under warranty shall be paid by CRESTRON, shipping by standard ground carrier. [. . . ]