User manual CRESTRON ST-4T8T

[. . . ] 5703 Contents · i CRESTRON Hand-Held Wireless Transmitter Description Functional Description The ST-4T and ST-8T are hand-held radio-frequency (RF) transmitters. The units are designed to operate with the SmarTouch STS via the ST-CP, control processor. The hand-held transmitter is available with four (ST-4T) or eight (ST-8T) button controls. Depression of any fixed button on the button panel initiates a RF signal transmission to the ST-CP. [. . . ] Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. As of the date of manufacture, the unit has been tested and found to comply with specifications for CE marking. Setup Identity Code Every hand-held wireless transmitter communicating with either the ST-CP requires a unique RF identity code (ID CODE). There are 254 possible two-digit hexadecimal alphanumeric codes ranging from 01 to FE. To maintain code diversity within SmarTouch STS, use codes between 10 and FE for the transmitters. NOTES: The RF ID CODE on the hand-held transmitters is factory set to 11. Select ViewPort from the Tools menu; the "Crestron Performance Viewport" dialog box appears. 4 · Hand-Held Wireless Transmitter Operations Guide - DOC. 5703 CRESTRON Crestron Performance Viewport Dialog Box From the Options menu in the dialog box, select Set Transmitter ID to open the "Set Transmitter ID" dialog box. Click OK to confirm. Set Transmitter ID Dialog Box Programming STS VisionTools for Windows contains sample projects, ST4T. prj and ST8T. prj, that can be used when programming the hand-held wireless transmitters. Simply copy the respective sample project by selecting Copy Project from the File menu of an open project. The "Copy Project" dialog box is displayed. Operations Guide - DOC. 5703 Hand-Held Wireless Transmitter · 5 CRESTRON Copy Project Dialog Box NOTE: The illustration above shows what the "Copy Project" dialog box would look like if the programmer were to copy the ST-4T sample project with the new project name, remote-1. As illustrated, a "From" and "To" field is provided. If the desired project is not present in the field, directly key in the path name (at the From: box) or select Browse to display the "Open" dialog box and scroll through directories to establish the correct path of a desired source for the copy. Once source and destination paths have been chosen, select Copy to initiate project copying. By default, all copied graphic files are copied to the same directory as the project or touchpanel. The sample projects for the hand-held transmitters have one page each. The ST-4T page and ST-8T page have four and eight momentary-type buttons, respectively. Each large button has two join numbers associated with it, one for each half of the button. Commands such as VOLUME UP and VOLUME DOWN are usually assigned to the separate button halves; operation of each half is achieved by pressing down on that side of the button. Notice the join number assignments for each button. 6 · Hand-Held Wireless Transmitter Operations Guide - DOC. 5703 CRESTRON Open Page of ST4T. PRJ DO NOT reassign join numbers in the new project, since they represent the physical location of actual buttons on the transmitter. Use STS/VTW to assign device commands when customizing the SmarTouch system. [. . . ] Verify that the NET ID for the receiver is properly set to match the SIMPL program. NOTE: After changing the ST-CP identity code, disconnect and reconnect the network connector. RF ID or IR ID is Verify that the RF ID is properly set to match incorrectly set. Program does not Verify correct program is loaded in system match hardware. [. . . ]