User manual CRESTRON MPS-100

[. . . ] Crestron MPS-100 Multimedia Presentation System 100 Operations Guide This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Important Safety Instructions · · · · · · · · Read these instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or groundingtype plug. [. . . ] 6527 Crestron MPS-100 Multimedia Presentation System 100 Name the Output PROJECTOR_ DEL INS < > · Turn the volume control clockwise or counterclockwise (or press the k or j buttons) to select a new letter (uppercase or lowercase) or number. To delete a character, position the cursor under the character to be deleted and press the soft button labeled DEL. To insert a space, position the cursor where the space is to be inserted and press the soft button labeled INS. Press ENTER to save the new name and return to the Output Naming menu. Press MENU to cancel the operation and return to the Output Naming menu. · Network Setup The network settings of the MPS-100 can be configured and reviewed from the front panel using the Network Setup menu. NOTE: Some changes to network settings may require a reboot to take effect. Access the Network Setup Menu To access the Network Setup menu: · · · Set the IP Address Access the menu as described on page 31. Press the k or j buttons until "** NETWORK SETUP **" is displayed on the LCD. To exit the Network Setup menu, press MENU. The MPS-100 uses TCP/IP communications for communications between network devices, a PC, and RoomView Help Desk software. For information on using DHCP to obtain an IP address, refer to "Set the DHCP Mode" on page 44. To manually set an IP address: · · Access the Network Setup menu as described above. Press the k or j buttons until "** IP ADDRESS **" is displayed on the LCD and press ENTER to display the IP Address controls. The current IP address will be displayed. Operations Guide ­ DOC. 6527 Multimedia Presentation System 100: MPS-100 · 41 Multimedia Presentation System 100 Display the IP Address Crestron MPS-100 ** IP ADDRESS ** 000. Brackets will appear around the first part of the IP address. Change the IP Address ** IP ADDRESS ** [000] 000. 000 · · Turn the volume control clockwise or counterclockwise to select a number. To change a different section, press the soft button under the section to be changed. To save the new address and return to the Network Setup menu, move the cursor to the right-most section and press ENTER. Press MENU to cancel the operation and return to the Network Setup menu. · · Set the Subnet Mask The MPS-100 can be configured to use an IP Subnet Mask for TCP/IP communications. To set the address of the IP Subnet Mask: · · Access the Network Setup menu as described on page 41. Press the k or j buttons until "** SUBNET MASK **" is displayed on the LCD and press ENTER to display the Subnet Mask controls. The current IP address of the Subnet Mask will be displayed. 42 · Multimedia Presentation System 100: MPS-100 Operations Guide ­ DOC. [. . . ] Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number and return address. Products may be returned for credit, exchange or service with a CRESTRON Return Merchandise Authorization (RMA) number. Authorized returns must be shipped freight prepaid to CRESTRON, 6 Volvo Drive, Rockleigh, N. J. or its authorized subsidiaries, with RMA number clearly marked on the outside of all cartons. [. . . ]