User manual CRESTRON LEPB-5

[. . . ] Compatibility · Box Mounted Dimmers ­ Must use a 120V, 600W Incandescent version of the following families: Monet, Illumatech, Mural, Sureslide, True Touch, Touch Point, and Home Control. NOTE: For dimmers that include a Neutral wire, the dimmer Neutral wire must be connected. For more information go to www. leviton. com FCC COMPLIANCE STATEMENT This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. [. . . ] There are no other or implied warranties of any kind, including merchantability and fitness for a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration of any such implied warranty, including merchantability and fitness for a particular purpose, is limited to two years. Leviton is not liable for incidental, indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment, lost sales or profits or delay or failure to perform this warranty obligation. The remedies provided herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise. Only) 1 800 405-5320 (Canada Only) www. leviton. com DI-000-PE400-00B WARNING: IF YOU ARE NOT SURE ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT A QUALIFIED ELECTRICIAN. NOTE: The Power Extender must be installed in a 1900 Box with Raised Cover or a properly grounded metal 2-gang wall box, 3. 5" (8. 9 cm) deep (refer to Figure 1A and1B). Depending on the application and the number of connections, more space may be needed. WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT BREAKERS OR FUSES AND TEST THAT POWER IS OFF BEFORE WIRING!Remove 1/2" (1. 3 cm) of insulation from each circuit conductor in wall box. Connect lead wires per appropriate WIRING DIAGRAM and FIGURE 2 as follows: All connections to the output terminals should be made using #12 AWG wire. Carefully position all wires to provide room in wall box for Power Extender. When mounting, all PEAUXS must be spaced 4-1/2" above and below each unit for proper ventilation and heat dissipation (refer to Figure 4). Mount Power Extender to outlet box with "TOP" facing up (refer to Figure 3). For Panel Mounting (not shown), Proceed as follows: 4-1/2" (11. 4 cm) Minimum a. The enclosure must be in accordance with all local and national electrical codes. Leviton DOES NOT recommend using a door to enclose the front of a panel, since this restricts airflow to the controls. If mounting multiple controls in an enclosure: · Ambient temperature within an enclosure "MUST REMAIN BETWEEN" 32°-104°F (0°-40°C). [. . . ] TROUBLESHOOTING · The Power Extender is not powered - Circuit breaker is OFF. · The load does not turn ON, but the Power Extender is powered - The dimmer is OFF. - The dimmer is connected to a separate circuit, and the circuit breaker is OFF. [. . . ]