User manual CRESTRON LEPB-2 LEPB-3

[. . . ] NOTE: Hi-lume® is a registered trademark of the Lutron Electronics Co. , Inc. · Low-end adjustment available for setting the minimum brightness level. · Works with any Dimensions 3200 Series Multizone Controller/Dimmer to extend load capacity on any zone. 2 Gang Raised Cover 2 Gang Raised Cover Raised Cover Mounting Screws (4 Places) 1900 Box 1900 Box DESCRIPTION The Leviton Power Extender, Cat. [. . . ] If mounting multiple controls in an enclosure: · Ambient temperature within an enclosure "MUST REMAIN BETWEEN" 32°-104°F (0°-40°C). · If not mounting in a metal enclosure, all units "MUST" be mounted in a wall box. To improve heat dissipation of controls, remove the faceplate from the unit. LIMITED 2 YEAR WARRANTY AND EXCLUSIONS Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that this product at the time of its sale by Leviton is free of defects in materials and workmanship under normal and proper use for two years from the purchase date. Leviton's only obligation is to correct such defects by repair or replacement, at its option, if within such two year period the product is returned prepaid, with proof of purchase date, and a description of the problem to Leviton Manufacturing Co. , Inc. , Att: Quality Assurance Department, 59-25 Little Neck Parkway, Little Neck, New York 11362-2591 (In Canada send to Leviton Mfg. of Canada Ltd. , 165 Hymus Blvd. , Point Claire, (Quebec), Canada H9R 1E9). This warranty excludes and there is disclaimed liability for labor for removal of this product or reinstallation. This warranty is void if this product is installed improperly or in an improper environment, overloaded, misused, opened, abused, or altered in any manner, or is not used under normal operating conditions or not in accordance with any labels or instructions. There are no other or implied warranties of any kind, including merchantability and fitness for a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration of any such implied warranty, including merchantability and fitness for a particular purpose, is limited to two years. Leviton is not liable for incidental, indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment, lost sales or profits or delay or failure to perform this warranty obligation. The remedies provided herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise. Only) 1 800 405-5320 (Canada Only) www. leviton. com DI-000-PE200-00A-Pilot OTHER CAUTIONS: 1. WITH ALUMINUM WIRE USE ONLY DEVICES MARKED CO/ALR OR CU/AL. NOTE: The Power Extender must be installed in a 1900 Box with Raised Cover or a properly grounded metal 2gang wall box, 3. 5" (8. 9 cm) deep (refer to Figure 1A and 1B). Depending on the application and the number of connections, more space may be needed. WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT BREAKERS OR FUSES AND TEST THAT POWER IS OFF BEFORE WIRING!Remove 1/2" (1. 3 cm) of insulation from each circuit conductor in wall box. Connect lead wires per appropriate WIRING DIAGRAM and FIGURE 2 as follows: All connections to the output terminals should be made using #12 AWG wire. Carefully position all wires to provide room in wall box for Power Extender. All Power Extenders must have 4-1/2" spacing above and below each unit for proper ventilation and heat dissipation (refer to Figure 4). [. . . ] · No full range dimming - Remove wallplate if necessary and ensure the Power Extender trim adjusment (refer to Figure 3) is set to its fully counter-clockwise (ccw) minimum level. TABLE 1 Cat. PE200-1, 120V ­ For use with Advance Mark XTM 120V Dimming Ballasts Advance Mark XTM Part No. REZ-1T32 REZ-1T32 REZ-1T42 REZ-2Q26 REZ-132 REZ-2S32 REZ-3S32 REZ-132 REZ-2S32 REZ-3S32 REZ-1TTS40 REZ-2TTS40 Max. [. . . ]