User manual CRESTRON LEPB-1

[. . . ] PE100-1 Rating: 1920W/VA-120VAC, 50/60Hz Incandescent Magnetic Low-Voltage Neon/Cold Cathode For more information go to www. leviton. com 2 Gang Raised Cover DESCRIPTION The Leviton Power Extender, Cat. PE100-1, will emulate the characteristics of the dimmer that it is connected to in terms of dimming range and resolution. Compatibility · Box Mounted Dimmers ­ Must use a 120V, 600W Incandescent version of the following families: Illumatech, Mural, True Touch, Toggle Touch, Touch Point, and Home Controls. [. . . ] Leviton is not liable for incidental, indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment, lost sales or profits or delay or failure to perform this warranty obligation. The remedies provided herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise. Only) 1 800 405-5320 (Canada Only) www. leviton. com DI-000-PE100-00A-Pilot INSTALLATION INSTRUCTIONS WARNING: TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH APPROPRIATE ELECTRICAL CODES AND REGULATIONS. WARNING: IF YOU ARE NOT SURE ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT A QUALIFIED ELECTRICIAN. NOTE: The Power Extender must be installed in a 1900 Box with Raised Cover or a properly grounded metal 2-gang wall box, 3. 5" (8. 9 cm) deep (refer to Figure 1A, 1B, 2A, and 2B). Depending on the application and the number of connections, more space may be needed. WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT BREAKERS OR FUSES AND TEST THAT POWER IS OFF BEFORE WIRING!Remove 1/2" (1. 3 cm) of insulation from each circuit conductor in wall box. Connect lead wires per appropriate WIRING DIAGRAM and FIGURE 2 as follows: All connections to the output terminals should be made using #12 AWG wire. Carefully position all wires to provide room in outlet box for Power Extender. All Power Extenders must have 4-1/2" spacing above and below each unit for proper ventilation and heat dissipation (refer to Figure 4). Mount Power Extender to wall box with "TOP" facing up as follows (refer to Figure 3). For Panel Mounting (not shown), Proceed as follows: 4-1/2" (11. 4 cm) Minimum a. The enclosure must be in accordance with all local and national electrical codes. Leviton DOES NOT recommend using a door to enclose the front of a panel, since this restricts airflow to the controls. If mounting multiple controls in an enclosure: · Ambient temperature within an enclosure "MUST REMAIN BETWEEN" 32°-104°F (0°-40°C). [. . . ] - The dimmer is connected to a separate circuit, and the circuit breaker is OFF. - Dimmer is mis-wired · Control Neutral (from dimmer) wire is not connected to the Neutral of the Line pair feeding the dimmer. · Dimmer is not an incandescent, 600W dimmer or a Monet Magnetic Lowvoltage. [. . . ]