User manual CRESTRON IG ADAGIO LABEL STRIP

[. . . ] AdagioTM Label Strip Installation Congratulations on purchasing your custom-engraved label strip from Crestron. [. . . ] Continue sliding the screwdriver behind the label strip until the top of the label strip slides out as shown below. 4. Continue sliding the screwdriver until the entire top of the label strip is visible. Remove the label strip by pulling the top of the label strip up from the Adagio component as shown below. 5. Repeat steps 1 through 4 for any other label strips. Installation Guide ­ DOC. 6504 Adagio: Label Strip · 1 Installing the Engraved Label Cover 1. Place the engraved label over the label area of the Adagio component until the label strip's integrated magnets snap the label cover into place. NOTE: Observe proper orientation so the letters are right-side up. Further Inquiries If you cannot locate specific information or have questions after reviewing this sheet, please take advantage of Crestron's award winning customer service team by calling the Crestron corporate headquarters at 1-888-CRESTRON [1-888-273-7876]. For assistance in your local time zone, refer to the Crestron website (www. crestron. com) for a listing of Crestron worldwide offices. [. . . ] 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888. CRESTRON Fax: 201. 767. 7576 www. crestron. com Installation Guide ­ DOC. [. . . ]