User manual CRAYOLA SPIN MAGIC

[. . . ] Do not use an extension cord to connect this appliance to electricity. Extension cords do not guarantee the required safety of the appliance (e. g. Be certain your appliance is properly installed and grounded by a qualified technician. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. [. . . ] This will remove any traces of salt from inside the wash cabinet. 17 Before using for the first time Salt indicator When the salt reservoir is empty, the "Salt-PC" indicator will light, indicating that it should be refilled with reactivation salt. Bypassing the salt indicator If your water is soft (below 8 gr/gal) the salt reservoir should not be filled with salt. Looking into the salt reservoir, you will see the top of the float chamber on the right hand side, a. After the reservoir has been filled, the water softener is automatically reactivated the next time the dishwasher is started. ^ Using a screwdriver, carefully pivot the float chamber towards the center of the reservoir. ^ Using needle nose pliers, pull the cap, b, off of the float chamber, and remove the float, c. Replace the float chamber cap, push the chamber back into its upright position, and replace the salt reservoir cap. The "Salt" indicator should no longer be lit. 18 Before using for the first time Rinse aid Rinse aid is recommended to prevent spotting on dishes and glassware. , Filling the rinse aid reservoir with detergent will damage the reservoir. Only pour rinse aid formulated for residential dishwashers into the reservoir. Adding rinse aid ^ Pour liquid rinse aid into the reservoir until it is visible on the surface of the screen. Failure to close it all the way will allow water to enter the reservoir during the wash program. ^ Add rinse aid before the first use and whenever the "Rise aid" indicator lights. ^ Press the button in the direction of the arrow until the flap springs open. 19 Before using for the first time Adjusting the dosage The dosage selector is preset to 3. Leave space between these metals. 22 Loading the dishwasher Cutlery basket ^ For the best cleaning results, spoons and forks should be placed in the basket with handles down. Knives and other pointed objects can be loaded with their handles up to prevent injuries. ^ Place small spoons into the slots on either side of the cutlery basket. 23 Loading the dishwasher Cutlery tray (SC units) The removable cutlery tray makes unloading flatware easy. Simply carry the cutlery tray to where the flatware is stored and put the entire basket away in one trip. For easier unloading cutlery should be grouped in zones, one for knives, one for forks, one for spoons, etc. Place knives with the cutting edge and forks with the prongs between the holders. Spoons should be placed in the opposite direction with the handles between the holders. Longer items such as soup ladles, cake slices, mixing spoons and long knives should be placed lengthwise in the indentation of the cutlery tray. Spoon heads should be placed in contact with at least one of the serrated retainers of the cutlery tray to ensure that water runs off freely. Spoons with thick handles may have to be placed as knives and forks with their heads in the holders. 24 Loading the dishwasher Upper basket Adjusting the upper basket On select models, the upper basket can be raised or lowered to accommodate tall items. ^ Slide out the upper basket. Load the upper basket with small, lightweight, or delicate items such as cups, saucers, glasses, dessert bowls and flat pans. Long items such as soup ladles, mixing spoons and knives can be set across the front of the upper basket. ^ Pull up the levers at the sides of the upper basket and adjust the basket height. [. . . ] ^ Close the flap so that the clip engages. ^ Return the filter so it lies flat in the base of the wash cabinet. ^ Lock the filter by turning the handle clockwise. , The dishwasher must not be used without the filter locked in place. 43 Cleaning and Care Cleaning the spray arms Sometimes particles of food get stuck in the spray arm jets. Remove the spray arms as follows: ^ Remove the cutlery tray (if present). ^ Press the top spray arm upwards to engage the inner ratchet and unscrew the spray arm. [. . . ]