User manual COWON IAUDIO X5V V1.0

[. . . ] 1. 0(E) 2 COPYRIGHT NO CE TI General · iAUDIO is a registered trademark of Cowon Systems. · This product is for home use only and cannot be used for commercial purposes. · The copyright for this manual belongs exclusively to Cowon Systems, and it is strictly prohibited to distribute this manual in whole or in part without prior written premission. · The copyrights for JetShell and JetAudio belong to Cowon Systems, and it is strictly prohibited to distribute them without prior written permission by Cowon Systems or to use them commercially. · The MP3 files created using the MP3 conversion feature of JetShell or JetAudio must be used for personal purpose only. It is against the copyright laws to use them for commercial purposes or services. · Cowon Systems abides by the regulations on phonograph records, videos, and games. [. . . ] Connecting to a PC. " - M3U files will be recognized up to 128KB, and the maximum number of folders that files can be saved in is 99, and the maximum number of songs that can be supported in an M3U file is 999. 3. Voice Record Mode (Recording Voice with Built-In Mic) Voice Record mode is a feature that can record voice with the built-in microphone. 1. Press the "PLAY" button to playback recorded files. - To playback recorded files using features such as search, you may run the files in Navigator using Digital AV mode. - If you were running Voice Record before turning the product off, it will resume in Voice Record mode when the power is turned on again. - When you are listening to music using the Recording feature setup for the "REC" button, you may still start recording immediately by pressing and holding the "REC" button. [Please refer to "4) Detailed Description of Features by Menu 7. - The recorded file can be verified in "VOICE" of the upper most folder. - The quality and capacity of the recording depends on the recording quality setup in addition to the reception. A new file will be created and start recording if the capacity is exceeded. - If there is less than 128MB space available on the hard disk, the recording will not start. If the available space becomes less than 128MB during recording, the recording will end. - Up to 999 files can be recorded. iAUDIO X5V Instructions for Different Modes 4. LineIn Record Mode(Recording Using a Stereo Cable) Line-In Record mode is a feature which allows the user to record sound from another audio device to iAUDIO using the stereo cable shipped with the product. 21 CDP Playback 1. Connect the headphone terminal of the CDP to Line-In terminal of iAUDIO with the stereo cable. Pressing the "REC" button will stop the recording and stand-by until the audio signals come in. Depends on the Auto Sync setup, [Please refer to "4) Detailed Description of Features by Menu 8. Pressing the "PLAY" button on the CDP will start the recording from iAUDIO. To listen to the recorded files, press the "PLAY" button after the earphone is connected. - To playback recorded files using features such as search, you may run the files in Navigator using Digital AV mode. - If you were running Voice Record before turning off the product, it will resume in Voice Record mode when the power is turned on again. - The recorded file can be verified in "VOICE" of the upper most folder. - The quality and capacity of the recording depends on the recording quality setup in addition to the reception. [Please refer to "4) Detailed Description of Features by Menu 8. [. . . ] Depending on the discharge status, it can take up to 10 seconds for the power to come back on even after connecting the adapter. (* RESET will cut off the power while not affecting the device itself. ) iAUDIO does not work when there are no saved files in it. iAUDIO does not respond at all. I can't hear any sound at all, or there is noise. See if there is an AV file saved in the device memory. You also can see if the remote control or earphone is connected to the device, or if the port is covered by any foreign objects. (If a foreign object contaminates the device, it can create noise. ) If an audio file is damaged, noise can result or the sound can be cut out. Set to English in the Country/Language menu or use the File Name menu in the ID3 tag control menu. [. . . ]