User manual COPPER JOHN CUP

[. . . ] You will need to adjust your scope level later during set up. Always use a open end wrench that is the proper size when making adjustments in this area. Pliers or adjustable wrenches can damage the nut and ruin your sight. A. N. T. S Assembly cont. Horizontal Block Windage Block Locking Screw Step 5 Insert the Double Axis assembly into the Windage Block. Make sure the horizontal stop screw is all the way against the Windage Block. [. . . ] Tighten the Windage Block Locking screw Step 6 Mount the sight block to the bow with the screws provided and securely tighten the mounting screws. bar into the block and choose your desired distance setting. Stop Screw Hint The horizontal stop screw will be useful when you are disassembling your sight for travel in its case. The stop screw makes sure your scope locates perfectly every time you reassemble your sight, keeping your windage dead on. Hint Once you have chosen your desired distance, it is helpful to mark your bar where the knob contacts it. This will aid you in setting the sight back to the your chosen position after you have removed your sight for travel. A. N. T. S Level Setup It is important when using any range adjustable sight that your scope is perpendicular with the frame (3rd Axis) and the scope is level with the earth (2nd Axis). The frame can also be leveled with the shooting string (1st Axis), but this is not crucial. It is common that shooters will adjust their 1st Axis so that it matches, or is level, with their natural cant or bow tilt while at full draw. Using a line level or similar device against the frame, hold the frame level and note the level in the scope. Raise or lower the flange nut on the end of the Double Axis Adjustment until both levels show that they are perfect. It will take 25 clicks to move your sight from dead center of the X ring line to the exact center of the X ring. General Maintenance Keep your A. N. T. S. If it gets wet, towel it off and allow it to dry completely before storing in its case. Lubrication is normally not necessary, but if you should feel the need to lube your sight, use only synthetic, non water soluble grease such as SuperLube®. Lube only the Brass Rear Bearings by putting a line of lube in their slots and running the elevation block up and down to distribute the lube, or you can lube the underside of the adjustment knobs by putting a drop on the knob and spinning the knob to distribute the lube. Be very sparing with the lubrication because excessive amounts of lube will attract dirt and grime which could hamper the performance of your sight. Lifetime Warranty Your A. N. T. S. Sight is warranted against defects in materials or workmanship to the original owner for the lifetime of the product*. The warranty is conditioned upon proof of purchase and other conditions listed below. IT IS IMPORTANT THAT YOUR SALES RECEIPT BE FILED IN A SAFE PLACE FOR FUTURE REFERENCE, AS REPAIRS WILL NOT BE PERFORMED UNDER WARRANTY WITHOUT A COPY OF THE DATED SALES RECEIPT. [. . . ] IT IS IMPORTANT THAT YOUR SALES RECEIPT BE FILED IN A SAFE PLACE FOR FUTURE REFERENCE, AS REPAIRS WILL NOT BE PERFORMED UNDER WARRANTY WITHOUT A COPY OF THE DATED SALES RECEIPT. will perform its intended function if used in accordance with the instructions provided. This Lifetime Warranty covers only the replacement parts, labor, and return ground transportation costs performed by Copper John Corp. [. . . ]