User manual CONWIN PRECISION AIR

[. . . ] Precision Air Inflator Instruction Sheet Getting Started · To prevent the risk of electrical shock, do not use the Precision Air Inflator outdoors when weather conditions are wet. · Prior to plugging the Precision Air Inflator into an electrical outlet, verify that the electrical rating (listed on the label on the back of the Precision Air Inflator) is suitable for outlet. [. . . ] Allows user to transport up to 4 plates at a time (using 2 sets) - ideal for on-the-job decorating. Riser is designed to fit standard 1/2" elextrical conduit. Setting the Precision Air Inflator 1 2 Balloon Size/Time Settings BALLOON SIZE APPROX. TIME SETTING 0. 7 SECONDS 1. 8 SECONDS 3. 3 SECONDS 6. 3 SECONDS 9. 8 SECONDS Reference the time setting chart to set the Precision Air for the proper balloon size. Set the appropriate number of Seconds by pressing the arrow buttons on the left side of the control panel digital display window. (Note: For 5" and smaller balloons, the second setting should be set at 00. ) Set the appropriate number of Tenths of a Second by pressing the arrow buttons on the right side of the control panel digital display window. 5" BALLOON 9" BALLOON 11" BALLOON 14" BALLOON 16" BALLOON Inflating Balloons with the Precision Air Inflator 1 2 3 Place the extension tip over the filling outlet when inflating 5" balloons or 260Qs. Place the neck of the balloon all the way down on the extension tip until the neck is touching the base of the tip. Remove the extension tip from the filling outlet when inflating 9" and larger balloons. This will insure the air enters the center of the balloon and the round shape of the balloon is maintained during the inflation process. 4 When inflating 260Q balloons hold the balloon over the filling outlet and pull the end of the balloon upward to allow the air to enter into the balloon more easily. Tap the foot pedal to begin the inflation cycle. When the system automatically shuts-off, remove the balloons from the outlets without allowing any of the air to escape. Using and Resetting the Counter Every time the foot pedal is pressed the cycle count will be displayed on the digital display windows. The time setting for the inflation cycle will disappear once the foot pedal has been pressed. To verify or change the time setting for the inflation cycle, press any of the arrow buttons on the control panel once. Press the Reset button in the center of the control panel to set the counter back to zero. Precautions: 1. The Precision Air features an automatic hot air vent that exhausts hot air out the bottom of the unit after each inflation cycle. [. . . ] Conwin's Portfolio Builder images are the perfect solution for making winning presentations to your clients. Thirty-two photo quality images are available in the full series. Visit www. ConwinOnline. com today! [. . . ]