User manual CONWIN HI-FLOAT INFLATOR

[. . . ] Press the "Mode" button on the control panel to select the desired mode. Important: When the setting is greater than 9. 9, the display number will blink to indicate the setting exceeds 10. 0. Choose the Mode you would like to operate in and follow the directions below. [. . . ] Reference the size setting chart to verify the preset amounts of Hi-Float® and helium. There's a groove at the top of the outlet that will hold the balloon in place for hands-free operation. After the Hi-Float® enters the balloon, pinch the neck of the balloon to prevent Hi-Float® from coating the outlet. Rub the balloon to evenly distribute the Hi-Float® and fully coat the inside of the balloon. (NOTE: Tap the foot pedal twice to reduce the 5-second delay to 3 seconds. ) 4. Wipe off any excess Hi-Float ® from the aluminum outlet before replacing the blue outlet cap. For Mode 3 only 4 Troubleshooting: If the unit is not fully inflating balloons with helium, see the section on Inflator Maintenance on the back page of the instruction sheet. Settings Chart Mode 3 (Hi-Float® & Helium) Balloon Size Hi-Float Test Amount 1/2 tsp. 2+ tbsp. ® Adjusting Pressure The second-stage helium regulator should be set at 70 PSI. To adjust the pressure, pull the knob up -clockwise increases the pressure, counterclockwise decreases the pressure. Press the knob down to lock it in place. Mode 1 (Hi-Float®) seconds 1. 7 3. 4 11. 7 12. 3 Mode 2 (Helium) seconds 1. 8 3. 7 9. 7 13. 8 9" 11" 16" 18" Time settings are in seconds for both Hi-Float ® and Helium. Set the unit to Mode 1 to test the amount of Hi-Float ® injected placing the measuring cup under the outlet. Use this chart as a guideline and adjust as needed. Refilling the Reserve Cylinder When the Hi-Float ® level drops below the refill line on the sight tube, add 2 quarts of Hi-Float ®. 1 2 3 1. Press the silver release tab on the helium supply line to remove the line from the cylinder. Open the pressure bleed valve on the HiFloat ® reserve cylinder cap to release the pressure from the cylinder. The valve is in the open position when the blue lever is in the horizontal position. 3. Repeat steps 1-5 of the Set-Up Instructions featured on front page. Automatic Foil Balloon Inflation Place the foil balloon over the brass inflating outlet. Pinch the neck of the balloon between your thumb and forefinger and press down on the outlet. Support the foil balloon in an upright position until enough helium has entered the balloon to hold it up. This insures the neck of the balloon does not fold over and restrict the flow of helium. [. . . ] Table Clamp #32040 Counter Mount #32180 Under-Counter Ribbon Dispenser This ribbon dispenser mounts to the Countertop Helium Outlet of your Remote Helium Set-up. Conwin #49047 20-Spool Ribbon Rack A compact, freestanding unit, featuring two ribbon cutters. With the top feed organizer, you can pull all the ribbons up at the same time! [. . . ]