User manual CONTINENTAL EDISON FE5ECI2

[. . . ] If the supply cord is damaged, it must be replaced by themanufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Do not allow the electric cables to touch the hot parts of the appliance.  Make sure that the power cord is not caught under or in the appliance and avoid damage to the power cable. We also recommend that you pay special attention during use and during cleaning. [. . . ] Note:If the supply LED bulb is damaged, it must Be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Remove the protective film from the product before putting it into service. installation (Mode extraction) If the wall has an opening to the outside, your hood may be connected as shown in the diagram below using the suitable exhaust pipe (not supplied), such as ductwork, flexible aluminum or other nonflammable material with an inside diameter of less than 150mm. Do not make any changes to the unit or its mounting bracket on the wall!Before installing the device, check the condition of the wall on which it will be fixed: the wall must be in good condition, it must not show any damage (cracks, sagging, humidity, . Do not drill a hole near old holes, even plugged It is imperative that you consult a building professional to use the anchoring system (screws, dowels, etc. ) appropriate to the material that constitutes your wall, as well as to the weight of the appliance. Do not modify the holes for securing the unit or its mounting bracket to the wall. Drill the wall with a drill of the appropriate size for the anchoring system. Before installing, make sure the unit is not plugged into an electrical outlet. Screw and tighten the bracket to the wall with the screws 3 Screws (ST4x30mm) and 3 wall plugs (not supplied). Place the range hood and hook it by using the two notches on the wall bracket. (If the extraction installation mode is chosen) Place the Ø150-Ø153mm plastic pipe (supplied) on the air outlet as shown below. If the size of your plastic pipe is Ø120 - Ø123mm , you must firstly assemble the adapter to the air outlet, as shown below. Screw the lower chimney bracket on the lower chimney by using 2 screws(ST4x8mm). Install the lower chimney on the appliance, and mark the holes position on the wall. Remove the lower chimney, then drill holes in the wall: hole with diameter 4 mm screw. Install the lower chimney on appliance again, then screw it to the wall with 2 screws of diameter 4 mm and the corresponding wall plugs (not supplied). Pull the upper chimney upwards to the target height and mark the holes on the wall. Pull out the upper chimney again, then fix it to the wall with 2 screws ST4x30mm. Recycling Mode: If you do not have an outlet to the outside, plastic pipe is not required and the installation is similar to above. And you need to assemble the carbon filters which are used to trap odors. [. . . ] (1) Install the range hood in a suitable location with good ventilation. (4) Do not forget to turn off the range hood once cooking is complete. Disassembly Information Do not disassemble the unit in a manner that is not indicated in the operating instructions. At the end of its life cycle, the appliance must not be disposed of with household waste. [. . . ]