User manual CONTINENTAL EDISON CECM6065S

[. . . ] Se trata de unos paneles de colores claros con acabado mate a los lados y/o el panel con acabado mate en la parte trasera del horno. Quite primero la lente del cristal y a continuación quite la bombilla. Se a pressão do gás utilizado for diferente da dos valores indicados ou se não for estável na sua área, poderá ser necessário para montar um regulador de pressão disponível na entrada de gás. São painéis com acabamento mate e cor leve nas laterais e/ou painel de acabamento mate na traseira do forno. [. . . ] Adjust the height of the antitilting bracket so that it lines up with the slot on the cooker and tighten the screw. Push the appliance towards the wall making sure that the anti-tilting bracket is inserted into the slot on the rear of the appliance. For safe operation, it is important that your appliance is correctly balanced. To increase the height of the appliance, turn the feet anti-clockwise. It is possible to raise the height of the appliance up to 30 mm by adjusting the feet. The appliance is heavy and we recommend that a minimum of 2 people lift it. Important: Specifications for the product vary and the appearance of your appliance may differ from that shown in the figures below. 1 Use of gas burners Ignition of the burners The position symbol above each control knob indicates the burner that the knob controls. Manual Ignition of the Gas Burners If your appliance is not equipped with an ignition aid, or in case there is a failure in the electric network, follow the procedures listed below. For Hob Burners: Push in the knob of the burner you wish to ignite and keep it pressed while turning it anti-clockwise until the knob is in the `maximum' position. Continue pressing the knob and hold a lit match, taper or other manual aid to the upper circumference of the burner. Move the ignition source away from the burner as soon as you see a stable flame. electrical ignition by control knob Push in the knob of the burner you wish to ignite and keep it pressed while turning it anticlockwise until the knob is in the 90 degrees position. The microswitch under the knob will create sparks through the spark plug for as long as the control knob is pressed. Flame safety device Hob burners Hobs equipped with a flame failure device provide security in case of an accidentally extinguished flame. If such a case occurs, the device will block the burners gas lines and will avoid any accumulation of unburned gas. Ignite the burner with the knob in the 'maximum' position; you can then adjust the flame length between the 'maximum' and 'minimum' positions. Do not operate the burners when the knob is between the 'maximum' and 'off' positions. If you see a yellow tip, lifted or unstable flame, switch the gas flow off, then check the assembly of burner caps and crowns once they have cooled. If the burner flames go out accidentally, switch the burners off, ventilate the kitchen with fresh air and wait at least 90 seconds before attempting re-ignition. To switch the hob burners off, turn the hob burner knob clockwise to the `0' position or so that the marker on the hob burner knob points upwards. You will find that the most economical way of using gas is to choose the correct size gas burner for your cooking pan size and to bring the flame to the 'minimum' position once boiling point is reached. [. . . ] Do not clean the enamelled parts while they are still hot from cooking. Open the locking catch (a) (with the aid of a screwdriver) up to the end position. Close the door until it almost reaches the fully closed position and remove the door by pulling it towards you. Do not leave vinegar, coffee, milk, salt, water, lemon or tomato juice on the enamel for a long time. [. . . ]