User manual CONSTRUCTA W7320F0EU

[. . . ] - Lay hoses and cables in such a way that there is no risk of stumbling. Hose and cable lengths depending on model Connection on left side or Connection on right side Remove transportation protection devices - Before using the appliance for the first time, remove all the transportation protection devices and retain for subsequent transportation of the appliance. - Keep the bolt, washer and sleeve screwed together. Water connection depending on model 100 cm 145 cm 145 cm 100 cm - Risk of electric shock!Do not immerse Aqua Stop safety device in water (contains an electric valve). [. . . ] Gently tilt the machine forwards and gather up the transportation safety fittings. If all the parts have not come loose and have not fallen on the floor: Put your hand through the machine's load opening, pulling the drum forwards until all the parts have fallen. 10 mm Depending on the connection - 1 hose clip 24-40 mm (specialist outlet) for connection of the siphon is also required. Built under appliance - 60 cm cavity width required. - Instead of the appliance cover panel, have a technician install a sheet metal cover * (* order no. WMZ 2420, WZ 10190). Water drainage Do not kink or protract the drainage hose. Insert covers. Installation area - Stability is important to prevent the machine from wandering!- Soft floors/floor coverings are not suitable. Drainage into a washbasin: The washbasin outlet must not be sealed by the plug: Secure the drainage hose from slipping out. Check that the water is pumped out quickly enough. If installing the appliance on a base - Secure the washing machine feet with retention plates * (* order no. WMZ 2200, WX 975600) Drainage into a siphon: Secure connection point with hose clip, 24-40 mm (dealer). If installing the appliance on a wooden joist ceiling - If possible, install the washing machine in a corner. see above). 1 2 3 4 Alignment Loud noise formation, intense vibrations and wandering" may be due to incorrect alignment! Transportation, e. g. if moving house After transporting and correctly installing and connecting the appliance, run the Empty auxiliary programme before starting the first washing programme. Align washing machine with spirit level. 1. Loosen lock nut in a clockwise direction with a wrench. 1. Before transporting the washing machine: 2. Check alignment of the washing machine with a spirit level and, if required, correct. 1. Remove the hoses. Customer service F Before calling customer service, please check whether you can eliminate the fault yourself. F If you require advice, even during the warranty period, you will incur costs for the call out of a technician. can find your nearest service in Please give customer service F Youproduct number (E Nr. )customerproductionthe enclosed list. the appliance. the and the number (FD) of E Nr. + Washing machine en FD 3 1 4 Product number Production number You can find the rating plate which contains this information in the frame of the open washing machine door and in the thick bordered box on the appliance rating plate at the back of the appliance. 2. 3. The lock nuts on all four appliance feet must be screwed tightly against the housing! Preparing and installing the transportation protection devices: F 2 Please help by quoting the product number and production number to prevent unnecessary call outs. [. . . ] 10A - LS L switch) Water pressure 100-1000 kPa (1-10 bar) Waste water pipe Height from floor: min. 100 cm Test programmes according to EN 60 456 1999 and IEC 60456 Ed. 3 1998: 02 4. Appliances which feature Aqua Stop can be left unattended during operation and it is not necessary to turn off the tap afterwards. [. . . ]