User manual CONSTRUCTA CP533V9

[. . . ] HQ 2SHUDWLQJ LQVWUXFWLRQV 9000 538 732 (9009) en Table of contents Additional options . 14 14 14 14 14 14 14 15 15 15 15 16 16 16 16 17 17 18 18 18 19 19 20 21 21 21 21 22 22 22 22 23 23 23 23 23 23 Safety instructions . 13 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. ­ Please dispose of the packaging material in an environmentally friendly manner. [. . . ] Different influencing factors such as water temperature or mains pressure may result in deviations. Y Express Wash/ Speed Perfect * The >>Express Wash/ Speed Perfect<< function can reduce the running time by approx. To obtain optimum cleaning and drying results at a reduced running time, water and energy consumption are increased. Switching on the appliance ­ Turn on the tap fully. The programme starts running. § Half load * If you have only a few items to wash (e. g. It is recommended to put a little less detergent in the detergent dispenser than for a full load. End of programme The programme has ended when the programme end display @ and the display of the executed programme are lit. Each time the Programme button 3 is pressed, the buzzing sound changes in 4 stages (from off to loud). ­ Close the door. 14 en Switching off the appliance Short time after the end of the programme: ­ Open the door. ­ Remove the utensils when they have cooled down. Terminating the programme (Reset) ­ Open the door. ­ Close the door. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Changing the programme After you have switched the appliance on, it is possible to change the programme within 2 min. If you want to change the programme afterwards, the appliance waits until the initiated programme section (e. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ Close the door. 15 en Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Filters The filters 1J keep large foreign objects in the rinsing water away from the pump. ­ After each wash cycle check the filters for residue and clean if required. ­ After unscrewing the coarse microfilter, you can take out the filter group. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. &RDUVH PLFURILOWHU ­ Remove any residue and clean filters under running water. [. . . ] Inlet rate: minimum 10 litres/minute Water temperature: cold water; hot water max. temperature 60 °C. 21 en Installation The required installation dimensions can be found in the installation instructions. ­ A built-under or integrated appliance which is installed subsequently as a free-standing appliance must be secured to prevent it from overturning, e. g. by screwing it to the wall or by installing it under a continuous worktop which is screwed to adjacent cupboards. [. . . ]