User manual CONSTRUCTA CP432J9

[. . . ] en Instructions for use 9000 045 127 (8409) en Index 4 6 7 8 9 10 11 15 Programme overview . Filling the special salt container Filling the rinse aid container Not suitable for the dishwasher Arranging crockery, glasses, etc. . en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Please dispose of packaging material properly: D The corrugated cardboard consists mainly of waste paper. [. . . ] Greater deviations may be caused by: different quantities of utensils inlet temperature of the water water pressure ambient temperature mains voltage tolerances and appliance-specific tolerances (e. g. temperature, water flow rate, etc. ) The water consumption values refer to water hardness value 2. Washing the dishes Switching on the appliance Turn on the tap fully. Select a programme with the programme selector 1 (rotate in a clockwise direction only). When the appliance has been switched on, the main switch is slightly recessed in the control panel. The programme starts. Programme sequence indicator While the dishes are being washed, the programme selector rotates in a clockwise direction and indicates how far the programme has progressed. End of programme The programme has ended when the pump noise is no longer audible and the programme selector has reached its initial position (12 o'clock position). Switching off the appliance Several minutes after the end of the programme: Switch off the main switch 5 . Turn off the tap Remove the utensils when they have cooled down. Interrupting the programme Switch off the main switch 5 . To continue the programme, switch on the main switch again. Changing the programme Switch off the main switch 5 . Set the programme selector 1 to the new programme (rotate in a clockwise direction only!). 18 en Note If the power supply is disconnected while the appliance is operating, e. g. by switching off the appliance or due to a power failure, all settings remain stored. Operation continues automatically as soon as the power supply is restored. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. Therefore you should occasionally have a careful look inside your dishwasher. Overall condition of the machine Check spray arm for grease and limescale deposits. If you find such deposits: Fill the detergent dispenser with detergent, start the appliance without utensils in the programme which has the highest wash temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Health hazard! Dishwasher salt Check the LOW SALT indicator up with salt, if required. 24 . Top Rinse-aid Check the level of liquid in the rinse-aid container 30 . Top up with rinse-aid, if required. 19 en Filters The filters 26 prevent large particles of food in the water from reaching the pump. When the appliance has finished washing, check the filters for particles of food and, if required, clean. After undoing the coarse micro-filter, the filter unit can be removed. Remove any particles of food and rinse the filters under running water. Insert the filter unit and tighten the coarse micro-filter. Spray arms Lime and remnants of food in the washing water can block the nozzles in the spray arms 22 and 23 and the arm mountings . Inspect the nozzles in the spray arms for blocked holes due to remnants of food. [. . . ] Pull out the appliance, carefully pulling the hose behind. Waste disposal Disposal Old appliances are not worthless rubbish. To prevent children from locking themselves in the appliance and suffocating, destroy the door lock and childproof lock (if fitted). Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. All plastic parts of the appliance are identified by internationally standardised symbols (e. g. [. . . ]