User manual CONSTRUCTA CA17524IL

[. . . ] D The wooden frames (if fitted) are made of residual wood and are untreated. Built-under and built-in appliances should always be installed under a continuous work surface which is attached to the adjacent cupboards, in order to ensure that the appliance is entirely stable. After the appliance has been installed, the mains plug should still be easily accessible. Not on all models: The plastic housing on the water input contains an electrically operated valve. [. . . ] Please observe the manufacturer's instructions printed on the detergent packaging when determining the correct dosage. Important Due to the different solvency properties of the detergent tablets supplied by various manufacturers, the cleaning efficiency of the detergent may not be fully utilised by short programmes. It is recommended to use washing powder for these programmes. If you are using detergent in tablet form, read the manufacturer's recommendations on the packaging in order to determine where the tablets should be placed inside the dishwasher (e. g. Make sure that the lid on the detergent compartment is closed, even if you are using tablets. 15 en CAUTION IMPORTANT NOTE ON THE USE OF COMBINED CLEANING PRODUCTS Please note the following when using "combined cleaning products" which eliminate the need for a rinsing agent or salt, for example: Some products with a built-in rinsing agent are only used to their full effect in certain programmes. This type of product does not generally produce the desired effect with automatic programmes. Products which eliminate the need for regeneration salt can only be used within a certain water hardness range. If you wish to use these combined products, please read the instructions carefully and heed any notes on the packaging. Contact the manufacturer of the cleaning agent if you have any questions, particularly if: the crockery is very wet once the programme has finished. Any problems which arise as a direct result of the use of these products are not covered by our warranty. 16 en Programme overview This overview lists the max. The programmes supplied with your appliance are indicated on the fascia. Type of crockery e. g. china, Nonpots/pans, delicate cutlery, glasses, etc. Press the A and C programme buttons simultaneously and hold them pressed for approx. The PROGRAMME END indicator and the indicator for the programme that has just been terminated light up. To restart the dishwasher, set main switch 1 to ON again and select desired programme. Special dishwasher salt Check the LOW SALT indicator Top up with salt, if required. 5 Changing the programme It is possible to change the programme selection after you have switched the dishwasher on, provided that you have not yet closed the door. If it is necessary to change the programme after this, the programme cycle that has already begun (e. g. washing) will still carry on to the end. . Rinse-aid As soon as the rinse-aid refill indicator lights up on the control panel 6 , refill with rinse aid. Filters The filters 25 prevent larger remnants of food or other objects from getting inside 19 en the pump. The filter system consists of a filter cylinder, a flat fine filter and, depending on the model, a microfilter (*). Inspect the filters for obstructions every time the dishwasher has been used. Remove any food remnants and clean the filters under running water. Spray arms Lime and remnants of food in the washing water can block the nozzles in the spray arms 22 and 23 and the arm mountings . Inspect the nozzles in the spray arms for blocked holes due to remnants of food. Clean both spray arms under running water. Reassembly: Insert the filter system and screw down with the filter cylinder. 3 2 1 0 Refit the spray arms. Ensure that the lower arm has locked into place and the upper one is screwed tight. 20 en Pump * * on applicable models Larger remnants of food that have not been trapped by the filters and have been left in the water can cause a blockage in the pump. [. . . ] Using the enclosed parts, connect the waste water hose to the drainage spigot of the siphon. Ensure that the drainage hose is not kinked, crushed or twisted (ensure that there is no sealing cover which prevents the waster water from flowing away!). 25 en Removing the appliance It is essential, when removing the appliance, to observe the following sequence: First, disconnect the appliance from the power supply. Pull out the appliance, carefully pulling the hose behind. Waste disposal Disposal Old appliances are not worthless rubbish. To prevent children from locking themselves in the appliance and suffocating, destroy the door lock and childproof lock (if fitted). [. . . ]