User manual CONCORD CONFORT LINE

[. . . ] Turn the rotary handle at the front of the seat shell upwards (1) and at the same time push the seat shell into the upright position (2). Hold the seat shell with your thumbs on the left and right side and use your fingers to pull the grey levers as far as they will go in the direction of the arrow. Keep the levers extended and lift the seat shell upwards and out until the green component is visible above the snap mechanism. 5 Position the lower belt section (1) (lap belt) under the blue lap belt guides (see illustration). [. . . ] Adjusting the seat to the child’s size / adjusting the head support and harness 4. 5 0040-04 The central adjuster is located at the front of the seat, beneath the cover. Release the central adjuster by pushing the small flap up (see illustration), and then pull the belts through to the front (do not pull on the belt padding!On the rear of the seat shell, separate the two belts from the connecting piece. Adjusting the seat to the child’s size / adjusting the head support and harness 4. 7 0042-07 Then pull the two belts out to the front through the backrest and the seat cover. Now thread both belts from the front through the cover and into the required slot. Pull the two metal clasps on the back of the seat out of their recesses and fit them through the belt openings in the seat shell. On the back you must thread both belts back into the connecting piece, then tighten the belt at the front by the central belt. Please check that the left and right harness belts are both adjusted in the same way. Adjusting the seat to the child’s size / adjusting the harness / shortening the belts 0252-02 4. 9 0143-04 click On the back of the seat, clip the metal clasps back into position. Thread the belts back into the connecting piece, as shown in the illustration. If you cannot tighten the child seat belt sufficiently by pulling on the central adjuster at the front of the seat, then it will be necessary to shorten the belt system. Adjusting the seat to the child’s size / shortening the belts 4. 11 0051-06 Remove the seat shell from the base unit and lay the shell upside down on a clean surface. Release the elastic tapes on the cover and pull the cover back a little. Lever out the metal clasps secured on the bottom of the shell, and thread them through the large side opening and the small slot (see illustration). Adjusting the head support / adjusting the seat to the child’s size 4. 14 0054-06 click When does the shortened belt system need to be returned to its lengthened setting?If, after releasing the child seat belt by means of the central adjuster, it does not pull forwards sufficiently to allow the belt system to be closed, then the belt system needs to be lengthened. To do this proceed as follows: Remove the seat shell from the base unit and lay the shell upside down on a clean surface. [. . . ] It is approved for general use in vehicles in accordance with UN-ECE Regulation 44, Amendment 04 and fits most, but not all, passenger vehicle seats. It can be assumed that the system will fit correctly if the vehicle manufacturer states in the vehicle manual that the vehicle is suitable for the installation of a “universal” child restraint system for the relevant age group. This child restraint system has been classified as being of the “universal” class, satisfying stricter conditions than previous models which do not bear this label. If in doubt, please consult the manufacturer of the child restraint system or the retailer. [. . . ]