User manual CONCORD 390AF

[. . . ] Otherwise passengers risk injury during the journey or in the event of an accident. Pass the three-point belt across the front of the child to the seat belt buckle, and fasten it in the same way as for an adult. Insert the lap belt (F) into the belt apertures (G) on the seat shell (I) on both sides, and the diagonal belt (D) into the belt aperture on the side with the buckle. Adjust the head section to the appropriate height by pressing the adjustment handle (B) and pushing the head section. [. . . ] Adjust the head section to the appropriate height by pressing the adjustment handle (B) and pushing the head section. The head section may be adjusted to seven heights, and it must click into place when the adjustment handle is released. The shoulder belt guide (C) should be slightly above the top of the child's shoulder. At the same time, the shoulder belt should pass centrally between the child's neck and the outer edge of the shoulder. Pull the belt taut so that the lap belt and diagonal belt are well positioned and ensure that the belts are not twisted. If your vehicle is fitted with a seat belt height adjuster, adjust its height accordingly. When you wish to remove the child from the seat, all you need to do is open the buckle and pass the strap back across the child. To remove the shoulder belt from the slot, press down the securing hook (C1) and pull the belt forwards (Figure 3). It is nonetheless important to ensure that the straps are always correctly positioned each time the seat is used. If you have any doubts about installation, please contact us to check. As a result of the very long period of use of the (390AF) restraint system, it is natural that the seat covers and some other parts will suffer varying levels of wear and may have to be replaced, depending on the duration of their use and how often they are used. Therefore we are unable to offer guarantees which extend beyond a period of six months. If you require replacement parts, contact your child and baby stockist, the relevant department in department stores, car accessory store or mail order company. A full list of accessories for CONCORD child seats is also available from the above. The lock of the seat belt must not be placed over the edge of the lap belt. In case of doubt, or if you are uncertain about something, please contact CONCORD. The belts must run only in the positions specified in the instructions and along the contact areas on the seat. If the seat used has a front airbag, we recommend the car seat be adjusted as far back as possible. In addition, for cars with airbags the instructions in the car's operation manual must be heeded. The shoulder belt (diagonal belt E) must pass forwards from the vehicle bracket to the shoulder strap slot (C). [. . . ] In addition, for cars with airbags the instructions in the car's operation manual must be heeded. The shoulder belt (diagonal belt E) must pass forwards from the vehicle bracket to the shoulder strap slot (C). Ithasbeentestedand approved pursuant to ECE Regulation 44, Amendment series 04 for general use in vehicles and will fit in most, but not all cars. Itmaybeassumedthatthesystemhasbeenfittedcorrectlyifthevehicle manufacturer states in the owner's handbook that the vehicle is suitable for fitting a "universal" child restraint system for the relevant age group. [. . . ]