User manual CONCORD 250BV

[. . . ] Pass the upper belt section (2) (diagonal belt) around the outside of the base unit and insert it into the blue belt clip. Tension the belt as shown in the illustration, and close the blue belt clip. Pass the car seat belt over the top of the base unit and secure the belt in the buckle. Always check that when the seat shell is inserted a green dot is visible on both sides through the opening on the sidepieces. [. . . ] Open the belt buckle and open the child seat belts outwards to lie on the armrests. Then put the child into the seat shell so that its back rests against the backrest. Please check that both the shoulder and lap belts are tensioned equally. To take the child out, press the red "Press" button on the belt buckle of the harness system. Fit both belt parts together (see illustration) and push them into the belt buckle so that they engage with an audible "click". Adjusting the seat to the child's size / adjusting the head support and harness 4. When the child is strapped in, the shoulder belt should feed horizontally to the back or incline slightly upwards, see illustration (A). If the shoulder belt feeds downwards as shown in the illustration (B), then the belt must be repositioned and inserted through the next slot up. To adjust the shoulder belt positions, the seat shell must be removed from the base unit (see 1. Adjusting the seat to the child's size / adjusting the head support and harness 4. The central adjuster is located at the front of the seat, beneath the cover. To remove the cover, the seat shell must be removed from the base unit. Release the elastic tapes located on the back of the cover at the points marked in red in the illustration. Keep pressing the grey lever on the belt tensioner down and pull the car seat belt in the direction of the arrow to unwind it from the ratchet shaft. Lever out the metal clasps secured on the side or bottom of the shell and push them back through their slots as illustrated. Pull the buckle padding away from the belt buckle and thread the belt buckle down and out through the cover. If the child's body weight exceeds 8 kg, the factory-fitted pelvic insert should be removed. Removing the seat covers to wash: The cover is composed of two parts which are secured to the seat by means of Velcro tape, buttonholes and tapes. Once these ties have been released the two parts of the cover may easily be removed. To fit the covers, proceed in the reverse order (seat shell and head section). When they come into contact with moisture, especially during washing, the cover fabrics can easily fade. Information on the use of child seats together with an airbag should be observed with particular care. [. . . ] Secure luggage and other items to reduce the risk of injury in the event of an accident. The use of accessories and replacement parts is not permissible and shall lead in the event of contravention to the expiry of all claims under the warranty and of all liability claims. Suitable for cars with three-point (lap and diagonal) seat belts tested in accordance with ECE Regulation 16 or a comparable standard. As the period of use for this restraint system (250BV) is very long, it is natural that seat covers and other used parts will each receive different degrees of wear and tear depending on the individual duration and intensity of use and will need to be replaced. [. . . ]