User manual COLEMAN PMA525500

[. . . ] IMPORTANT ­ Please make certain that persons who are to use this equipment thoroughly read and understand these instructions and any additional instructions provided prior to operation. * * * * * * * 11 HP Tecumseh OHV engine Cast-iron cylinder sleeve Low oil sensor Receptacles on control panel CordKeeperTM 5 gallon plastic fuel tank Portability Kit with pneumatic tires To the original retail consumer against defects in material and workmanship for a period of two (2) years from the date of retail purchase and is not transferable. This two year warranty applies only to products used in consumer applications. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. IMPLIED WARRANTIES: Any implied warranties, including the Implied Warranties of Merchantability and Fitness For A Particular Purpose, are limited in duration to one (1) year from the date of retail purchase. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. HOW TO OBTAIN WARRANTY PERFORMANCE: Replacement parts and service are available from Coleman Powermate, Inc. Locate your nearest Service Center by calling TOLL FREE 1-800-445-1805. In the unlikely event a Service Center can not be located you may call Coleman Powermate, Inc. To the extent any provision of this warranty is prohibited by federal, state, or municipal law, and cannot be preempted, it shall not be applicable. This warranty gives you specific rights, and you may also have other rights which vary from state to state. CordKeeperTM Restraint The CordKeeperTM restraint is a unique feature used to prevent plugs from being pulled out of the 120-volt receptacles. 25" bolt (item 35) and 3/8 washer (item 21) through the wheel (item 31), then through the wheel bracket on the carrier, with the offset side of the wheel hub against the wheel bracket. Assemble the rubber feet (item 32) to the foot bracket (item 41) using a 1/4-20 x 1. Thread a 5/16-18 x 1" bolt (item 14) with a 5/16 washer (item 34) through the mounting holes and thread a 5/16 washer (item 34) and a 5/16 nyloc nut (item 22) to the bolt to secure the foot bracket to the carrier. Slide 7/16 x 2" bolt (item 43) through handle as shown in diagram and secure with 7/16" nyloc nut (item 45). Apply aerosol hairspray or similar adhesive to the handle (item 39), and then slide the handle grip (item 44) onto the handle. [. . . ] Note B: These are standard parts available at your local hardware store. Under no circumstances should an unqualified person attempt to wire into a utility circuit. Electrical: For models approved for the City of Los Angeles (PL's), the ampacity of the phase conductors from the generator terminals to the first over current device shall not be less than 115 percent of the nameplate rating of the generator. [. . . ]