User manual COBRA XRS 9540

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual COBRA XRS 9540. We hope that this COBRA XRS 9540 user guide will be useful to you.


COBRA XRS 9540 : Download the complete user guide (1612 Ko)

Manual abstract: user guide COBRA XRS 9540

Detailed instructions for use are in the User's Guide.

[. . . ] Introduction Important Information and Customer Assistance · Important Information Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Operating Instructions Safety Alert Use of this product is not intended to, and does not, ensure that motorists or passengers will not be involved in traffic accidents. [. . . ] NOTE When initially choosing your IntelliMute activation point, a setting of approximately 300 to 600 RPMs above idle is recommended. You can reset the activation point at any time to fit your individual preferences and driving style. Setting the IntelliMute Activation Point Your detector must be installed in your vehicle. Depending on whether the unit is in Tone Alert or Voice Alert mode, you will hear a series of beeps or voice messages as you follow the steps on page 11. To Set the IntelliMute Activation Point Press and hold the IntelliMute button for two seconds. Tone Two beeps Voice Set Engine Revs Visual Display Press IntelliMute button again at desired RPMs None Rev your engine to None the level you wish to set (recommend slightly above idle) and hold revs steady for two seconds. At the desired rev level, press and release the IntelliMute button. IntelliMute Not Set IntelliMu. . . None Three beeps IntelliMute Set IntelliMute Set! Please tr. . . NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn off. Tone Four beeps Voice IntelliMute Not Set, Please Try Again followed by IntelliMute Off Visual Display IntelliMute not set Please try again IntelliMute Off 11 IntelliMute Off Intelli Mute Off One beep 10 English Nothing Comes Close to a Cobra® Your Detector Settings Your Detector Settings Spectre 1 and VG-2 On Spectre1 Spectre1 Voice/Tone Setting You can set your detector to sound alerts with either a Voice or a Tone. In Voice Alert mode, you will first hear several tones, then a voice message announcing the type of signal detected, followed by more tones. The factory setting is Voice Alert mode. Dim Button Press and hold for two seconds Spectre 1 and VG-2 Off & VG2 & VG2 On Off To Turn VG-2 and Spectre 1 Alerts On and Off While no signal is being detected, press and hold the Dim button for four seconds. Tone On = Two Beeps Off = One Beep Voice Spectre VG-2 On Spectre VG-2 Off Visual Display V will blink twice in the display V will blink once in the display Mute Button Press and hold for two seconds To Change From Voice Alert to Tone Alert While no signal is being detected, press and hold the Mute button for two seconds. Tone One beep Voice Tone Alert Visual Display None Radar Alert Settings The detector allows you to choose whether it will show alerts on the X, K, and Ku bands. The factory settings are: X Band and K Band On; Ku Band Off. To Turn X Band On and Off While no signal is Tone being detected, press and hold both the Dim X On = Two beeps and Mute buttons for four seconds. X Off = One beep To Turn K Band On and Off While no signal is Tone being detected, press K On = Two beeps and hold both the Mute and City buttons for four seconds. K Off = One beep To Turn Ku Band* On and Off While no signal is being Tone detected, press and hold the City button Ku On = Two beeps for four seconds. Ku Off = One beep Voice Ku On Ku Off Visual Display X and K will blink twice in the display X and K will blink once in the display Nothing Comes Close to a Cobra® 13 Voice Visual Display X will blink twice in the display X will blink once in the display X On X Off To Change From Tone Alert Back to Voice Alert While no signal is being detected, press and hold the Mute button for two seconds again. Tone None Voice Voice Alert Visual Display None Voice Visual Display K will blink twice in the display K will blink once in the display K On K Off VG-2, Spectre 1 Alert Settings, K & Ku Band Detection The detector is undetectable by police VG-2 and Spectre 1 radar detector detectors and will alert you when such a device is in use near your vehicle. You can choose whether or not you want your unit to show VG-2 and Spectre 1 alerts. (See table on the next page. ) 12 English Your Detector Detection · Your Detector Detection Voice X Alert K Alert Ka Alert Ku Alert K Signal Detected Ka Signal Detected Detection Signals Detected Radar Signals, Voice and Visual Displays Type of Signal X Band Radar K Band Radar Ka Band Radar Ku Band Radar X Signal Detected Visual Display X and Signal Strength K and Signal Strength Ka and Signal Strength Ku and Signal Strength Ku Signal Detected The tables on the following pages show you the types of Signals your detector will detect, as well as the voice and visual alerts it provides for each of them. Audio Alerts In Voice Alert mode you will first hear several tones, then a voice message announcing the type of signal detected, followed by more tones. In both Voice Alert and Tone Alert modes, a distinctly different alert tone is used for each type of signal detected (including separate tones for each laser signal). For X, K, Ka and Ku band radar signals, the tones will repeat faster as you approach the signal source. The repeat rate of the tones gives you useful information about the signal detected. (See responding to alerts on page 17. ) X--2 K---3 - _ Ka-----5 ---_ _ Ku----4 -- Laser Signals, Voice and Visual Displays Type of Signal LTI 20-20* LTI Ultra-Lyte* Kustom Signals ProLaser* Kustom Signals ProLaser III* Voice Laser Alert Laser Alert Laser Alert Laser Alert Kustom Signals ProLaser Visual Display Laser 20/20 Laser UltraLyte Laser Pro Laser Laser Pro Laser 3 Kustom Signals ProLaser III Visual Display An indication of the type of signal detected will appear in the DigiView Data Display. [. . . ] Additional patents may be listed inside the product or pending. 20 English Nothing Comes Close to a Cobra® 21 Warranty Warranty · Customer Assistance Product Service and Trademark Acknowledgement · Limited 1-Year Warranty For Products Purchased in the U. S. A. Cobra Electronics Corporation warrants that its Cobra 12 Band Radar/Laser Detectors, and the component parts thereof, will be free of defects in workmanship and materials for period of one year from the date of first consumer purchase. This warranty may be enforced by the first consumer purchaser, provided that the product is utilized within the U. S. A. Cobra will, without charge, repair or replace, at its option, defective 12 Band Radar/Laser Detectors, products or component parts upon delivery to the Cobra Factory Service Department, accompanied by proof of the date of first consumer purchase, such as a duplicated copy of a sales receipt. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE COBRA XRS 9540




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual COBRA XRS 9540 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.