User manual COBRA MT 600UK QUICK START GUIDE

[. . . ] Insert round connector of wall charger into the charge jack located at the top of the radio. The wall charger has two (2) round connectors which enables you to charge either one (1) or two (2) radios at a time. Insert Connector It is not recommended to recharge batteries more than 24 hours. Use only the supplied rechargeable batteries and wall charger for recharging your Cobra microTALK® radio. [. . . ] In addition to the DCS icon, either OFF or the small numbers next to the channel number will flash on the display. If DCS and OFF are flashing, press the CHANNEL UP or CHANNEL DOWN button to exit OFF and proceed to select a privacy code; or, if DCS and the small numbers next to the channel number are flashing, press the CHANNEL UP or CHANNEL DOWN button to select a privacy code. When your desired privacy code is displayed, choose one of the following: a. Press the MODE button to enter the new setting and proceed to other functions. Press the LOCK button to enter the new setting and return to LISTENING MODE. Do not press any buttons for 15 seconds to enter the new setting and return to LISTENING MODE. Mode Button Select VOX Channel Buttons English Mode Button DCS OFF DCS Privacy Codes Select Privacy Code Channel Buttons In VOX Mode, your microTALK® radio can be used "hands-free, " automatically transmitting when you speak. You can set the VOX sensitivity level to fit the volume of your voice and avoid transmissions triggered by background noise. When your desired VOX Mode setting is displayed, choose one of the following: a. Press the MODE button to enter the new setting and proceed to other functions. Press the LOCK button to enter the new setting and return to LISTENING MODE. Do not press any buttons for 15 seconds to enter the new setting and return to LISTENING MODE. Voice Activated Transmit (VOX) MODE FUNCTIONS OPERATION Mode Button Select VOX Sensitivity Level Channel Buttons English To Set the VOX Sensitivity Level: 1. Press the MODE button until the VOX icon flashes and the current sensitivity level is displayed. The current sensitivity level is displayed with the letter "L" and a number 1 to 5, 5 being the most sensitive level and 1 being the least sensitive level. Press the CHANNEL UP or CHANNEL DOWN button to change the setting. 3. When your desired VOX sensitivity level is displayed, choose one of the following: a. Press the MODE button to enter the new setting and proceed to other functions. Press the LOCK button to enter the new setting and return to LISTENING MODE. Press the LOCK button to return to LISTENING MODE on either the channel or channel/privacy code that was displayed before you entered Mode Functions or the channel on which, during scanning, you last transmitted or received. MODE FUNCTIONS OPERATION Select Channel Mode Button English Select Scan Privacy Codes Channel Buttons Your microTALK® radio can automatically scan the CTCSS privacy codes (01 to 38) within one (1) channel. While in LISTENING MODE, press the CHANNEL UP or CHANNEL DOWN button to choose the channel on which you wish to scan the CTCSS privacy codes. Press the MODE button until the Scan icon, CTCSS icon and the small numbers flash on the display. Press the CHANNEL UP or CHANNEL DOWN button to begin scanning CTCSS privacy codes within the channel you selected. CTCSS Privacy Code Scan The Scan icon will continue to be displayed when CTCSS privacy code scan is On. Your radio will continue to scan CTCSS privacy codes and stop as an incoming transmission is detected. [. . . ] Press the MODE button to enter the new setting and return to LISTENING MODE. Press the LOCK button to enter the new setting and return to LISTENING MODE. Do not press any buttons for 15 seconds to enter the new setting and return to LISTENING MODE. The setting you select will be saved when you turn your radio off and on again. [. . . ]