User manual COBRA MT 200 QUICK START GUIDE

[. . . ] 9498 MT200-EU-British4F 4/10/06 2:38 PM Page 1 Radio Controls and Indicators Ta l k B u t t o n Press and hold to communicate with others. With the microphone about five cm (2 inches) from your mouth, speak in a normal voice. [. . . ] Insert the supplied three AAA rechargeable batteries (also works with non-rechargeable alkaline batteries). Replace battery compartment cover and belt clip. Pull Latch Up Belt Clip Insert Batteries Wa l l C h a r g e r Radio Charger Jack To c h a r g e b a t t e r i e s i n r a d i o : 1. Insert round connector of wall charger into the charge jack located at the top of the radio. The wall charger has two round connectors which enables you to charge either one or two radios at a time. Use only the supplied rechargeable batteries and wall charger for recharging your Cobra microTALK® radio. Non-rechargeable alkaline batteries can also be used. Battery Compartment Cover Wa l l C h a r g e r 2 English 9498 MT200-EU-British4F 4/10/06 2:38 PM Page 3 Backlit LCD Display Channel Number While in Standby mode or when selecting a channel, shows current channel (1 through 8). When adjusting the volume, shows current level (1 through 8). Tr a n s m i t I c o n Visible when transmitting a message. Receive Icon Visible when receiving a message. Battery Low Icon Blinks when battery power level is low. Your microTALK® radio has a unique circuit designed to extend battery life. If there are no transmissions within 10 seconds, the radio will automatically switch to Battery Save mode. [. . . ] This declaration applies to all specimens manufactured in accordance with the attached technical documentation described in Annex II of the Directive which forms part of this declaration. Assessment of compliance of the product (class 2. 6) with the requirements relating to the essential requirements according to Article 3 R & TTE was based on Annex IV of Directive 1999/5/EC and the following standards: Radio Spectrum: EN 300 296-1 V1. 1. 1 (2001-03) EN 300 296-2 V1. 1. 1 (2001-03) EMC: EN 301 489-1 V1. 4. 1 (2002-08) EN 301 489-5 V1. 3. 1 (2002-08) Electrical Safety: IEC 60950-1:2001 / EN 60950-1:2001 RF Exposure: EN 50392 (2004-02) DUBLIN, IRELAND MIKE KAVANAGH 4 English [. . . ]