User manual COBRA ESD 7400 QUICK START GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual COBRA ESD 7400. We hope that this COBRA ESD 7400 user guide will be useful to you.


COBRA ESD 7400 QUICK START GUIDE: Download the complete user guide (991 Ko)

Manual abstract: user guide COBRA ESD 7400QUICK START GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] 480-529-P Version A Nothing Comes Close to a Cobra® English English Introduction Table Of Contents Introduction Important Information . 17 Nothing Comes Close to a Cobra® 1 Your Detector Installation · Your Detector Installation Installation Where To Mount Your Unit You will get optimum performance from your detector if you Mount it at a point approximately in the center of the vehicle, as low as possible on the front windshield without obstructing the unit's view of the road either to the front or rear. You can also mount it directly on the dashboard. Windshield Mounting Dashboard Mounting Windshield Mounting 1. Push the bracket firmly onto the windshield. The unit's lens must not be blocked and the LaserEye should have a clear view out the back window to allow 360° detection. The LaserEye Should Have A Clear View 4. [. . . ] Tone Two (2) beeps Visual Display None To Change From City Mode Back To Highway Mode Press and release the City button again. Tone Two (2) beeps Visual Display Cty off 6 English Nothing Comes Close to a Cobra® 7 Your Detector Detection · Your Detector Detection Type of Signal X Band Radar K Band Radar Ka Band Radar X Signal Detected Detection Signals Detected The tables on the following pages show you the types of Signals your detector will detect, as well as the visual alerts it provides for each of them. Radar Signals And Visual Displays Visual Display X is Steady K K /Ka is Steady /Ka is Steady Ka Signal Detected Audio Alerts A distinctly different Alert tone is used for each type of signal detected (including separate tones for each laser signal). For X, K and Ka band radar signals, the tones will repeat faster as you approach the signal source. The repeat rate of the tones gives you useful information about the signal detected. (See responding to alerts on page 11. ) K Signal Detected · X K/Ka L V/S Cty · X K/Ka L V/S Cty · X K/Ka L V/S Cty Visual Display An indication of the type of signal detected will appear in the UltraBright data Display. During radar alerts the letters X or K/Ka will appear. X Signal Detected K Signal Detected Ka Signal Detected Laser Signals And Visual Displays Type of Signal LTI 20-20* LTI Ultra-Lyte* Kustom Signals ProLaser* Kustom Signals ProLaser III* Visual Display L is Steady L is Steady L is Steady L is Steady · X K/Ka L V/S Cty · X K/Ka L V/S Cty · X K/Ka L V/S Cty During laser alerts the letter L will appear. Laser Signal Detected * Your detector provides 360° detection of these signals. Laser Signal Detected · X K/Ka L V/S Cty · X K/Ka L V/S Cty During VG-2 and Safety Alerts, the letters V/S will appear. VG-2 Alert Signal Detected Safety Alert Signal Detected · X K/Ka L V/S Cty · X K/Ka L V/S Cty 8 English Nothing Comes Close to a Cobra® 9 Your Detector Detection Type of Signal Emergency Vehicles Road Hazards Trains Safety Alert Signal Detected Your Detector Detection Safety Alert Signals And Visual Displays Visual Display V V V Instant-On Detection /S is Steady /S is Steady /S is Steady Your detector is designed to detect Instant-On speed monitoring signals, which can suddenly appear at full strength. Your detector does not emit signals that can be detected by VG-2, but does detect VG-2 signals and will alert you when a device is in use near your vehicle. Safety Alert® Traffic Warning System FCC-approved Safety Alert transmitters emit microwave radar signals that indicate the presence of a safety-related concern. Depending on the frequency of the signal emitted, it can indicate a speeding emergency vehicle or train, or a stationary road hazard. Because these microwave signals are within the K band frequency, most conventional radar detectors will detect Safety Alert signals as standard K band radar. Your detector, however, is designed to differentiate between standard K band and Safety Alert signals, and give separate alerts for each. Safety Alert transmitters can be found in limited numbers in all 50 states, but the number is growing. Depending on your location, you may not receive these alerts regularly and may often encounter emergency vehicles, trains and road hazards without being alerted. As the number of transmitters increases, these alerts will become more common. When you receive such an alert, please watch for emergency vehicles ahead of you, on cross streets and behind you. If you see an emergency vehicle approaching, please pull over to the right side of the road and allow it to pass. I Can LIDAR operate through glass?However, the laser pulse also can be received through glass to trigger an alarm by your detector. Because LIDAR operates by line of sight, the person using it cannot drive the vehicle, aim and operate the gun all at the same time. It is legal in all 50 states. I 12 English Nothing Comes Close to a Cobra® 13 Your Detector Maintenance And Specifications · Warranty Warranty And Product Service Maintenance Maintenance Of Your Radar Detector Your detector is designed and built to give you years of trouble-free performance without the need for service. If your unit does not appear to be operating properly, please follow these troubleshooting steps: I I I I Make sure the power cord is properly connected. Make sure the socket of your vehicle's cigarette lighter is clean and free of corrosion. Make sure the power cord's cigarette lighter adapter is firmly seated in your cigarette lighter. (Unscrew the ribbed end cap of the cigarette lighter adapter and examine the fuse. [. . . ] 5) Ship prepaid and insured using a traceable carrier such as United Parcel Service (UPS), Federal Express, or Priority mail with delivery confirmation. Ship to: Cobra Factory Service, Cobra Electronics Corporation, 6500 West Cortland Street, Chicago, IL 60707 U. S. A. 6) Please allow three (3) to four (4) weeks before contacting us about the status of your service. If your unit is under warranty, it will either be repaired or replaced upon receipt, depending on the model. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE COBRA ESD 7400




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual COBRA ESD 7400 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.