User manual CLIFFORD TAZOR 2

[. . . ] If you press the panic button while driving, the siren will sound, the lights will flash and the doors will lock to shield you from the assailant (mays require optional relays). Remote Door Lock/Unlock Outputs -- No more fumbling with keys in the dark or bad weather!A press of a button on the remote simultaneously arms Tazor II and locks your car's power locks. Another press disarms and unlocks (may require optional relays. ) Remote Controlled Chirp Muting-- Silently arm or disarm the system whenever you wish by pressing both buttons on the remote control. [. . . ] So if a thief disconnects the power and then restores it in an attempt to start the car, the system will re-arm and instantly sound the siren while immobilizing the vehicle. 2 Your 2-button/3-channel remote controls The 2-button/3-channel remote controls are miniature radio transmitters powered by a 12-volt batteries. Range is up to 100 feet (a weak remote control battery will reduce range). You will use it to arm and disarm the system, lock* and unlock* the doors, activate the panic feature, command options such as a remote trunk release, power window operation, or other accessory. TO ARM THE SYSTEM . The dashboard LED will flash repeatedly and the car doors will automatically lock. * Press button I again. One chirp and one parking light flash confirm disarming, and the doors will automatically unlock. * Press both buttons I+II. The system will arm or disarm with all the indications noted above except the chirp confirmations. The parking lights will flash repeatedly and the siren will blare for 30 seconds or until you press button I again to turn it off. Button II (channel 2) can optionally pop the trunk or activate another optional accessory. TO DISARM THE SYSTEM . . TO REMOTELY CONTROL AN OPTION AutoArmingTM If this feature is enabled and you forget to remotely arm, Tazor II automatically arms itself 30 seconds after the doors are closed. For your convenience, if you re-open any door(s) within the 30-second countdown, AutoArming will restart from the beginning once all doors are closed. Tazor II has these additional AutoArming features: AutoArming enable/disable: If you prefer, you may deactivate or reactivate the AutoArming feature. See User-selectable features on page 6. AutoArm & Lock: To ensure you can't accidentally lock your keys inside the car, the system is factory-set not to lock* the doors upon AutoArming. To change this setting, see User-selectable features on page 6. Instant AutoArming bypass: Prevents AutoArming when fueling the vehicle and other times when you wish to temporarily bypass AutoArming. To do so, rapidly turn the ignition switch to "ON" then "OFF" twice. You will hear a single siren chirp to confirm that the system will not AutoArm. Your Tazor II will revert to its normal operating mode when you next start the engine. * Some vehicles require optional relays to control the vehicle's power locks. 3 Valet mode Whenever the system is put in valet mode, all of the system's security features are switched off. For instance, when having your car serviced, washed or parked by a valet. NOTE: If you temporarily lose the use of your remote controls, you can disarm the system by enabling valet mode. Turn the ignition switch to its "ON" position or start the engine. The system's LED will glow continually for on-going visual confirmation of valet mode. To exit valet mode 1. Turn the ignition switch to its "ON" position or start the engine. The system's LED will turn off to confirm that the system is in its normal operating mode. How to interpret the chirps and parking light flashes When you use the remote control, the system responds with chirps and parking light flashes. [. . . ] If the mechanic needs to interrupt power, your system will automatically return to its valet mode state when power is restored; there will be no alarm activation and no need to provide your mechanic with your remote control and instructions on how to use it. 5 User-selectable features Your Tazor II vehicle security system allows you to set many of its features to your own personal preferences. We have made the programming procedures very simple: to make a change, you just flick the valet switch a few times. · Flick the valet switch back and forth 4 times (you'll hear a chirp each time to help you count to the total of 4 chirps). The system will sound one more chirp to confirm that the AutoArming setting is now off (1 chirp = off, 2 chirps = on). [. . . ]