User manual CLIFFORD MATRIX RS III

[. . . ] now with MODEL RSIII OWNER'S GUIDE Remote Start with Security System limited lifetime consumer warranty Directed Electronics, Inc. ("Directed") promises to the original purchaser to repair or replace with a comparable reconditioned model any Directed unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following conditions are met: the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer's name, telephone number and address; the authorized dealers name, telephone number and address; complete product description, including accessories; the year, make and model of the vehicle; vehicle license number and vehicle identification number. All components other than the unit, including without limitation the siren, the remote transmitters and the associated sensors and accessories, carry a one-year warranty from the date of purchase of the same. This warranty is non-transferable and is automatically void if: the original purchaser has not completed the warranty card and mailed it within ten (10) days of the date of purchase to the address listed on the card; the unit's date code or serial number is defaced, missing or altered; the unit has been modified or used in a manner contrary to its intended purpose; the unit has been damaged by accident, unreasonable use, neglect, improper service, installation or other causes not arising out of defects in materials or construction. [. . . ] You must check with the installer to verify the programming for your individual unit. The remote control will beep twice (or vibrate). The disarm icon (8) will flash for five seconds and the Disarmed Status Icon (6) will be displayed on the LCD. silent mode To temporarily turn off the arm or disarm chirps, use Silent ModeTM. Simply press for less than one second before arming or disarming, and the confirmation chirp(s) will be eliminated for that one operation only. If you want the arm/disarm chirps turned off permanently, your dealer can do this for you. © 2002 directed electronics, inc. 25 note: The Warn Away® response to lighter impacts is bypassed if the system is armed using Silent Mode. This ensures that no chirps will be emitted by the siren in an area you want chirp-free. Only the Warn Away® response is bypassed. All arm/disarm page notifications will still be generated by the remote control in silent mode. panic mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your remote control. To stop Panic Mode press note: Once Panic Mode has been entered, the siren will sound for 30 seconds. The remote control will beep twice (or vibrate) when the system enters panic mode. The remote control will not generate a Page Notification when panic mode is exited. valet mode You can prevent your security system from passive arming by using Valet Mode. In Valet Mode, the security system will not arm, even with the remote control, but all convenience functions (door locks, trunk release, remote starting, etc. ) will continue to work normally. 26 © 2002 directed electronics, inc. To enter or exit Valet Mode: 1. The status LED will light solidly if you are entering Valet Mode, and it will go out if you are exiting Valet Mode. The remote will not generate a Page Notification when entering or exiting Valet mode using the Valet switch. To enter or exit Valet Mode using the transmitter: DRW-35 1. again. The status LED will light solidly if you are entering Valet Mode, and it will go out if you are exiting Valet Mode. The remote control will generate alarm/disarm Page Notifications since the observing buttons are used when entering and exiting valet mode. The status LED is the only way to ensure the system has entered/exited valet mode. © 2002 directed electronics, inc. 27 remote start This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system. If interior heating or cooling is desired, the climate controls must be preset, and the fan blower must be set to the desired level prior to remote starting the vehicle. important!(1) Never remote start your vehicle when the keys are in the ignition, except when performing Valet® Take-Over, and (2) Never start the vehicle if it is not in either PARK or NEUTRAL. To remote start the vehicle: 1. Simultaneously press for one second. and on the remote control 2. The parking lights will flash to confirm that the vehicle will attempt to start. A remote start Page Notification with a unique two-tone beep (or vibration) will be generated and the LCD will display the Start (20) icon as long as the vehicle is running. note: the remote will generate a Page Notification with a different unique two-tone beep (or vibrate) and the Start (20) icon will turn off when the remote start shuts down 4. In gasoline vehicles, the engine will start 4 seconds after the parking lights flash. In diesel vehicles, the engine will start when the WAIT-TO-START indicator on the vehicle's dash goes out. 28 © 2002 directed electronics, inc. 5. [. . . ] The arm/disarm chirps can be either full volume or 6 decibels quieter than the full alarm blast. Using the 998T Bitwriter, the engine can be programmed to run for any duration ranging from 1 to 60 minutes. After the programmed run time, the engine will shut down and will not restart, unless in Timer Mode. 44 © 2002 directed electronics, inc. While the remote start system is running the engine, the parking lights of the vehicle can flash on and off or come on and light steadily. security & convenience expansions Listed below are some of the many expansion options available. Please consult your dealer for a complete explanation of all the options available to you. Audio Sensor: Metal on glass, glass cracking, and breaking glass produce distinctive acoustic signatures. The 506T audio sensor uses a microphone to pick up sounds, then analyzes them with proprietary acoustic software to determine if the glass has been struck. Backup Battery: The 520T keeps the system armed, triggers the alarm and keeps the starter interrupt active if main battery is disconnected. Hood Lock: Prevents the vehicle's hood from being opened without a key, keeping thieves away from the system's siren, the battery connections, and other components under the hood. Field Disturbance Sensor: An invisible dome of coverage is estab- lished by installing the 508D "radar" sensor. [. . . ]