User manual CLIFFORD INTELLISTART

[. . . ] WARNING IntelliStart is designed to be used ONLY on a fuel-injected, gasoline powered vehicle with an automatic transmission. [. . . ] If the engine over-revs (e. g. , if the throttle is stuck), IntelliStart will automatically and immediately shut down the engine. If a thief pressed the brake pedal while the ignition switch is "OFF, " the engine will immediately shut down. 1 How to Remotely Start the Engine Button 2 on your car alarm remote control (or any other button you assign) will remotely start (or shut down) the engine: 1. Press and hold button 2 until you see your vehicle's parking lights flash twice, visually confirming that the remote command to start the engine has been accepted. (NOTE: A single flash indicates a fault condition, e. g. , the hood is open). Once the engine starts, it and all preset accessories (heater, defroster, A/C etc. ) will run for 20 minutes if the vehicle is left unattended. During that time the parking lights will remain on as continuing visual confirmation. If you do not enter and drive the vehicle within 20 minutes, the IntelliStart automatically shuts down the engine and turns off the parking lights. You may shut down or restart the engine anytime by pressing button 2 again. To Drive the Car After the Engine Has Been Started Remotely 1. [. . . ] · NEVER remotely start with a person or pet in the car (exhaust fumes may leak into the passenger compartment). · In case of transmission slippage, NEVER remotely start the engine if you or someone else is directly behind or in front of the vehicle. © Copyright Clifford Electronics, Inc. , 1997 31-126B/ISom/597 [. . . ]