User manual CLIFFORD 78

[. . . ] (If the system does not immediately respond, release and press the button again. This works better than holding the button down. ) The second remote can be used by a second driver, or kept as a spare. Additional remote controls or batteries can be purchased from any authorized Prime Dealer, or by calling Prime Security toll-free at 1-800-253-0334 (within the U. S. ) or 1-847-215-2233. Electronic Scan Prevention (ESP) Your system also includes ESP, which blocks electronic scanner codes preventing unauthorized operation of your system. 1 AMX78(3) Owner's Manual 0399 Instant Remote Control Code Deletion In the event of a lost or stolen remote control, all remote controls can be erased from the system memory preventing unauthorized system operation. [. . . ] Remote-Controlled Silent Arm/Disarm Press the remote SILENT button for 1-2 seconds to arm or disarm your system without the usual siren chirps. Silent Arm Indications The parking lights will flash twice, the doors will lock, the starter will be disabled and the LED will flash slowly. Silent Disarm Indications The parking lights will flash once, the doors will unlock, the starter will be enabled and the LED will turn off. 3 AMX78(3) Owner's Manual 0399 User-Programmable Long-Term Silent Arm/Disarm This feature allows you to completely disable the arm/disarm siren chirps until you decide to restore them. (See the "Programming Table for System Features" on page 9. ) Remote Panic with Safety LocksTM In a threatening situation, you can activate Remote Panic with Safety Locks. When activated, the siren will sound and the parking lights will flash. If you are inside your vehicle and the ignition key is "ON, " the doors will lock. If you are outside the vehicle with the ignition key "OFF, " the doors will unlock. To Activate 1. The siren will shut off and the parking lights will stop flashing. Interior Light Illumination When the alarm system is remotely disarmed, the vehicle interior light(s) will turn on for 30 seconds or until the ignition key is turned on. User-Programmable Passive Door Lock Your system will not automatically lock the doors when the alarm passively arms to prevent the keys and remote from being locked in the vehicle. If you prefer, you can easily program the alarm to automatically lock the doors every time the alarm passive arms. (See the "Programming Table for System Features" on page 9. ) User-Programmable Ignition-Controlled Door Lock/Unlock For the ultimate in security and convenience, your system is programmed to automatically lock your doors when the ignition key is turned "ON" or the engine is started, and will unlock when the ignition key is turned "OFF. " This feature can be programmed ON or OFF. (See the "Programming Table for System Features" on page 9. ) 4 AMX78(3) Owner's Manual 0399 Protected Valet Mode You should place your system in Protected Valet Mode whenever your vehicle is being serviced by mechanics, car wash personnel or driven by valet parking attendants. While in the Protected Valet Mode, all alarm functions are bypassed to prevent unauthorized or accidental arming. Remote-controlled door lock/unlock, trunk release and all optional accessories will still operate. To Turn on Protected Valet Mode 1. Turn the ignition key to the "ON" position or start the engine. The LED will turn on solid red to indicate the system is in the Protected Valet Mode. Turn the ignition key to the "ON" position or start the engine. The LED will turn off to indicate the system is no longer in the Protected Valet Mode. Turn the ignition key to the "OFF" position. LED System Status Indicator The LED on your vehicles dashboard or center console will inform you of the system status. LED Off On solid Slow flash Flashing in cycles Rapid flash Status System is disarmed In Protected Valet Mode System is armed See "Specific Intrusion Identification" on page 6. Passive arming Remote-Controlled Trunk Release Capability If you have the optional Trunk Release installed, simply press the remote control TRUNK button for 1-2 seconds to activate your vehicle electronic trunk release. The trunk will "pop" open (may require an optional relay). 5 AMX78(3) Owner's Manual 0399 Remote-Controlled Accessory Output This output allows you to add an optional remote-controlled accessory to your system such as a remote engine starter, window roll-up, garage door opener* or fuel door release. [. . . ] Automatic Malfunction Override In the event of a faulty sensor or alarm input trigger zone, the alarm, when remotely armed, will alert you by a series of chirps and parking light flashes. How to Interpret the Chirps and Parking Light Flashes When you press the remote control buttons, the system will respond with chirps and flashes of the parking lights to indicate the system status. An explanation of these chirp/flash acknowledgments is listed below. Number of chirps and flashes 1 chirp, 1 flash 2 chirps, 2 flashes 2 chirps and 2 flashes, then 4 chirps and 4 flashes 3 chirps, 3 flashes 4 chirps, 4 flashes Explanation Disarming of the alarm Arming of the alarm Armed and there is a sensor malfunction (automatically bypassed) Disarmed and there was an intrusion attempt Armed and there was a trigger malfunction (automatically bypassed) 7 AMX78(3) Owner's Manual 0399 User-Programmable Features All system and remote control programmable features are accomplished by turning the ignition key "ON" (or starting the engine) and flicking the valet switch on and off a preset number of times. Your system also allows you to add new remote controls in one step, delete lost or stolen remote controls or rearrange the factory preset remote control functions. Programming cannot be accessed while the system is in Protected Valet Mode indicated by the LED on solid red. [. . . ]