User manual CLIFFORD 3.3X

[. . . ] Responder LE Model 3. 3X Security and Remote Start Owner's Guide © 2008 Directed Electronics, Vista, CA Limited lifetime consumer warranty Directed Electronics. ("Directed") promises to the original purchaser to repair or replace (at Directed's election) with a comparable reconditioned model any Directed unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following conditions are met: the unit was purchased from an authorized Directed dealer, the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer's name, telephone number and address; the authorized dealers name, telephone number and address; complete product description, including accessories; the year, make and model of the vehicle; vehicle license number and vehicle identification number. All components other than the unit, including without limitation the siren, the remote transmitters and the associated sensors and accessories, carry a one-year warranty from the date of purchase of the same. ALL PRODUCTS RECEIVED BY DIRECTED FOR WARRANTY REPAIR WITHOUT PROOF OF PURCHASE WILL BE DENIED. [. . . ] The 2-way remote control will sound a short "error" tone, and blink the LOCK and Function indicators. Arming without the chirp (Silent Arm) Press the button at the bottom of the remote once, and then press the button. If no arm confirmation is received, the 2-way remote will give the Out Of Range signal. © 2008 Directed Electronics--all rights reserved While the system is armed Fail-Safe Starter Kill The starter is disabled by the system's Fail-Safe starter kill. Alarm Responses The security system can generate two levels of alarm: Warn Away - Soft siren chirps and flashing parking lights. The purpose of Warn-Away is to warn a would-be thief next to your vehicle that the vehicle is protected, but in a manner that does not call attention to it from more than a few feet away. Full Alarm Trigger Sounds the siren at maximum volume and flashes the parking lights. This can be programmed to any duration from 30 to 60 seconds manually. If in range, the 2-way remote will blink its indicator lights and sound the Revenger siren tones. Warn-Away response is triggered by: Lesser or lighter vibrations or impacts (detected by the Stinger Doubleguard shock sensor) Opening a door: the Progressive Door Trigger feature will sound the Warn Away response, followed immediately by Full Alarm Any attempt to start the car: the Progressive Ignition Trigger will first sound the Warn Away response, followed immediately by Full Alarm. An optional Proximity Sensor (508D) triggered in the outer zone. © 2008 Directed Electronics--all rights reserved Full Alarm response is triggered by: Heavier impact to the vehicle (detected by the Stinger Double-Guard shock sensor). Opening a door: the Progressive Door Trigger feature will first sound the Warn-Away response, followed immediately by Full Alarm. An optional sensor, such as an optional Proximity Sensor triggered in the inner zone. Paging Signals If the Full Alarm response is triggered, the 2-way remote control will be sent a paging signal by the in-car system. When the 2-way remote receives a Full Alarm paging signal, the remote will play Revenger siren tones and the indicator lights will flash. Sensor Page Signal Transmit LED: solid for Car 1, flashes for Car 2 Green LEDs alternately Red Function LED flashes for Sensor triggers Point of Entry Page Signal Transmit LED: solid for Car 1, flashes for Car 2 Green LEDs flash alternately Red Function LED lights solid for door, hood, or trunk triggers © 2008 Directed Electronics--all rights reserved Modified Arming Modes The Responder LE gives you an unprecedented level of control over how it will protect your car. "Normal arming" means that all the Responder LE security features are active automatically. Turning off the Warn Away response After arming, you can turn off the Warn-Away response on a one-time basis. Turning off the Sensor Full Trigger response You can completely disable the Stinger Doubleguard Shock Sensor and any added optional sensors on a one-time basis. All sensors will not be able to trigger the Warn-Away response or the Full Alarm response. the button twice. Note: The next time you arm the system, the shock sensor will work normally. © 2008 Directed Electronics--all rights reserved Silent Mode 2 - Turning off the siren You can turn off the vehicle siren and flashing lights on a one-time basis, leaving the system's paging feature as the only alarm response. In this mode, the siren cannot be triggered, but any trigger will cause the 2-way remote to be paged. button four times, and then press the within five Sensor Silent Mode In this mode, a sensor cannot trigger the siren, but will cause the 2- way remote to be paged. [. . . ] An input can be provided through a sensor, pin-switch or by existing systems in the vehicle, such as ignition or courtesy lights. In-vehicle status LED: A light used to indicate the status of your system. This sensor is mounted in the vehicle and designed to pick up impacts to the vehicle or glass. Trigger or Triggered Sequence: This is what happens when the alarm "goes off " or "trips. " The triggered sequence of your system consists of the siren sounding and parking lights flashing for the programmed duration. © 2008 Directed Electronics--all rights reserved Valet Button: A small push button switch located on your systems control center. [. . . ]