User manual CLIFFORD 12.2X

[. . . ] Model 12. 2X O Owner's Guide limited lifetime consumer warranty Directed Electronics ("Directed") promises to the original purchaser to repair or replace with a comparable reconditioned model any Directed unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following conditions are met: the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer's name, telephone number and address; the authorized dealers name, telephone number and address; complete product description, including accessories; the year, make and model of the vehicle; vehicle license number and vehicle identification number. All components other than the unit, including without limitation the siren, the remote transmitters and the associated sensors and accessories, carry a one-year warranty from the date of purchase of the same. This warranty is non-transferable and is automatically void if: the original purchaser has not completed the warranty card and mailed it within ten (10) days of the date of purchase to the address listed on the card; the unit's date code or serial number is defaced, missing or altered; the unit has been modified or used in a manner contrary to its intended purpose; the unit has been damaged by accident, unreasonable use, neglect, improper service, installation or other causes not arising out of defects in materials or construction. The warranty does not cover damage to the unit caused by installation or removal of the unit. [. . . ] If you wish to clear the NPC® memory, turn the ignition key on. NPC® is programmable. See Programming Options section of this guide. 28 © 2006 directed electronics auxiliary outputs (options) This system also supplies outputs that can control convenience options such as remote control trunk release and window automation. Channel 2 Trunk release: When connected, pressing seconds will remotely release the vehicle trunk lid. Channel 3 auxiliary output: When connected, pressing will immediately activate this output to control an additional convenience option. Channel 4 auxiliary output: When connected, pressing will immediately activate this output to control an additional convenience option. Channel 5 auxiliary output: When connected, pressing will immediately activate this output to control an additional convenience option. Channel 6 auxiliary output: When connected, pressing will immediately activate this output to control an additional convenience option. The remote will respond with a page notification consisting of an output tone (once) and the Yellow LED will flash 3-times. This occurs at the remote after the system has received the command to activate any of the Auxiliary outputs. and and and and for 1. 5 © 2006 directed electronics 29 shock sensor adjustment enter shock sensor adjustment mode : important: Prior to performing this procedure the system must be disarmed, the doors, trunk and hood must be closed, and the ignition must be Off. 1. The system will emit 1 long chirp to indicate entry into shock adjustment mode. The LED will illuminate continuously for the duration of shock adjustment mode. : note: When the shock sensor adjustment mode is entered, all other timers and operations are bypassed until adjustment mode is exited. adjusting the shock sensor setting 1. Increase Sensitivity--Press and release the button to increase shock sensor sensitivity by one step. When the shock sensor adjustment reaches maximum sensitivity the siren will emit 2 short chirps and then 1 long chirp. note: When the arm and disarm are programmed to a single button, then the AUX button is used to increase the sensitivity setting of the sensor. 30 © 2006 directed electronics 2. Decrease Sensitivity--Press and release the button to decrease shock sensor sensitivity by one step. When the shock sensor adjustment reaches minimum sensitivity (sensor is Off ) the siren will emit 1 short and then 1 long chirp. Testing Sensor--Use the heel of the palm of your hand to strike the door pillar of the car after an adjustment. The siren will chirp once if the impact was great enough to generate a full trigger. When desired setting is reached, sensor adjustment mode can be exited. exit shock sensor adjustment mode The adjustment mode will be exited if: No input from transmitter for 15-seconds. Valet button is pressed. The The The siren will emit 1 long chirp and the LED will extinguish which shock adjustment mode is exited. reset shock sensor to default setting The shock sensor can be restored to a default setting of 10 to facilitate re-adjustment at any time while in adjustment mode. Simultaneously press the © 2006 directed electronics and buttons. 31 2. The system will emit 3 chirps to indicate the sensor has been reset to level 10. [. . . ] Tilt Sensor: The 507M tilt sensor can be added to your system to protect your car when its parked. It can protect your vehicle from being lifted to protect your expensive rims. Valet Start System: For the ultimate in convenience, the Valet start system can start your vehicle, monitor engine functions, and power your climate control system with a push of a button. Over-rev protection, open-hood lockout, brake pedal shutoff, and automatic timer shutoff are all included. (This feature is only for automatic transmission, fuel-injected vehicles. ) © 2006 directed electronics 49 Ultrasonic Sensor: Providing a field of protection inside your car using the 509U Ultrasonic sensor to protect your belongings. 50 © 2006 directed electronics glossary of terms ASK Amplitude Shift Keying--a method of transmitting data. [. . . ]