User manual CLARION VMA773

[. . . ] 6-inch VMA573 and 7-inch VMA773 are high performance video monitors designed specifically for the mobile environment. Intended for use with other Clarion multimedia products, they can also be integrated with many other products as part of a complete mobile video solution. Features Two video inputs support simultaneous connection to both dedicated video source units and optional audio/video components, such as camcorders or videogames. The infrared remote control receiver output allows integration with select Clarion DVD unit. [. . . ] 14 Adjusting the picture If the temperature is normal and the picture still doesn’t look right, you may adjust the tint, color, brightness, and contrast. Press the Press the ( up key ) controls button to increase the adjustment . Each setting has 30 steps of adjustment range and is preset to 15 at the factory . Once you’ve adjusted the picture , wait a moment and the adjustment menus disappear . 15 Turning the unit off and on Press POWER at any time to turn the unit off. When you turn the vehicle’s ignition off , the monitor automatically shuts off. Switching between video sources If your vehicle has two video sources, for example, a DVD player goes to AV1 and a game console goes to AV2, you can easily switch between them. The monitor will display AV1 and press SOURCE key to select the input for AV2 for game console. Note : If you’re using only one video source, the screen remains dark when you select the unavailable source. 16 Playing two videos or games at once If your vehicle is equipped with two LCD monitors in the headrests and two video source units, two different videos or games can play at the same time. Each monitor transmits the infrared audio signal over its own channel, A or B. When a vehicle has two monitors, the default is to configure the monitor in the driver’s headrest to use IR channel A, and the monitor in the passenger’s headrest to use IR channel B. Note: You don’t need to select the IR channel if your vehicle has only one monitor. Disabling automatic power on Your monitor is preset at the factory to switch on when you turn on your vehicle’s ignition. However, you can set it up to remain the VMA off until you press POWER on the monitor. If you don’t wish to reset the settings, either press MENU again or wait for the monitor to exit the picture adjustment menus automatically. Note : If you reset the options and the monitor was set to source2 ( AV2 ), the monitor reverts to the default setting of AV1. The reset settings only valid for the Tint, Color, Brightness, Contrast, Volume that setting those parameter back to default value 15, and set to IR CHA, AUTOPOWER ON. Remote IR Function The LCD monitor comes with an IR receiver that works with Clarion remote control devices. Note: The IR receiver only functions with select Clarion multimedia equipment. 18 Connecting a video source The video sources you are using may be preinstalled for you, or your configuration may be designed to allow you to change devices. For example, returning from a day at the beach, you may disconnect your game from the game port and connect your camcorder to view the video you just shot . [. . . ] The monitor will function normally once it returns to its proper operating range . With a DVD player and widescreen DVD disc, there are black bars above and below the picture. Change the TV display mode to “ FULL WIDE” in the DVD player’s Setup menu. 29 After changing this setting, if there are still black bars, set the Display mode to “ FULL WIDE “ by push MENU key as mentioned before . [. . . ]